Slicktricky
Well-Known Member
I just installed my JLT catch can. Took about 1 min.
Sponsored
Same here, unplug one hose, plug in the JLT can. No clips, tools, brackets etc.I just installed my JLT catch can. Took about 1 min.
So I bought this version and I can't figure out the ridiculous bracket the way it's configured WILL NOT fit where it's supposed to go and I can't find any good videos on install there all for the GT not the Bullitt or Mach 1 ...
In order to make this bracket work it looks like I will have to make some modifications, if anyone knows about this please help out thanks
Unhook to hose clips, undo some screws, youre done in 5min lol I'll take my personal experience on how long it takes to empty it over that of a guy that couldn't even install it.No it isn't ...
I broke that same stupid clip. It is unobtanium. The dealer couldnāt find the part number and suggested I order the entire engine wiring harness, hoping itās on that.This piece.... This piece right here. Fuck this. I broke it 3 different ways and super glued it back. I'm not putting it back in. It's pointless pretty much.
I just left it unclipped. It serves no purpose. It doesn't even clip back on the same bolt in a clean fashion.I broke that same stupid clip. It is unobtanium. The dealer couldnāt find the part number and suggested I order the entire engine wiring harness, hoping itās on that.
someone find this part number!!!
You could try using a cable tie with a mounting hole to mount it back on the bolt stud. Only thing I could think of that would work.I just left it unclipped. It serves no purpose. It doesn't even clip back on the same bolt in a clean fashion.