JnBama
Well-Known Member
Replaced thin foam 25 watt center speaker with Boss 50 Watt from eBay. I have very bad hearing loss but it seems to have more of a kick and deeper sound.
Sponsored
Sponsored
ScubaSteve2020
Well-Known Member
Simple plug and play swap??Replaced thin foam 25 watt center speaker with Boss 50 Watt from eBay. I have very bad hearing loss but it seems to have more of a kick and deeper sound.
JnBama
Well-Known Member
. Cut off the connector and soldered Green wire to positive and Lime green or yellow stripe wire to negative post on speaker. It fit right in no trimming needed .
MAGS1
Well-Known Member
- Joined
- Mar 6, 2020
- Threads
- 96
- Messages
- 11,479
- Reaction score
- 18,830
- Location
- Somewhere in Middle America
- First Name
- Mark
- Vehicle(s)
- 2022 Mustang GT
Where was that one at?Went to a car show today. Was very relaxing.
Sponsored
GT Pony
Well-Known Member
- Joined
- Mar 13, 2015
- Threads
- 77
- Messages
- 9,402
- Reaction score
- 4,839
- Location
- Pacific NW
- Vehicle(s)
- 2015 GT Premium, Black w/Saddle, 19s, NAV
Finally got some smoked LED side marker lights to match the smoked "reflectors" on the rear fascia - they also match the stock 3rd brake light above the rear window. They fit well in the hole, and put out way more light at night than the stock tungsten 194 style bulbs. Hint: Use some needle nose pliers to release the front clip on the back side of the OEM side marker lights.
paulm1
Well-Known Member
- Joined
- Mar 4, 2022
- Threads
- 10
- Messages
- 568
- Reaction score
- 679
- Location
- Northeast PA
- First Name
- pau
- Vehicle(s)
- 2021 GT mustang
Installed gt 350 front calipers and 15" rotors with the help of the LMR brackets and a 5mm spacer.
Bit_the_Bullitt
Well-Known Member
Ah. You is one of dem fancy owners!Here it is…
Just kidding. Nice setup. Need something like that as the Bullitt is stupid low to the ground and my jack barely fits.
You'd think I'd check the height before I buy the jack. Too tall for my Bullitt, too short for wife's F150.
Sponsored
MAGS1
Well-Known Member
- Joined
- Mar 6, 2020
- Threads
- 96
- Messages
- 11,479
- Reaction score
- 18,830
- Location
- Somewhere in Middle America
- First Name
- Mark
- Vehicle(s)
- 2022 Mustang GT
Nice, I’ll have to keep my eyes peeled for shows down that way. I’m in the Aurora area.
gadgtfreek
Well-Known Member
- Joined
- Oct 12, 2020
- Threads
- 15
- Messages
- 1,144
- Reaction score
- 1,178
- Location
- Fairhope, AL
- First Name
- Jason
- Vehicle(s)
- 2021 GT Premium Shadow Black 10spd Auto
Borla S-type axle back installed to go along with the Borla Switchfire resonator delete.
Headless Horseman
Well-Known Member
- Joined
- Apr 5, 2021
- Threads
- 29
- Messages
- 377
- Reaction score
- 473
- Location
- Atlanta, Ga
- First Name
- Tim
- Vehicle(s)
- 2020 Mustang GT PP1
That's my setup! It creates the ultimate muscle car sound. No other mustang will sound like yours!! (Except mine!)
Do you also have the active exhaust?
gadgtfreek
Well-Known Member
- Joined
- Oct 12, 2020
- Threads
- 15
- Messages
- 1,144
- Reaction score
- 1,178
- Location
- Fairhope, AL
- First Name
- Jason
- Vehicle(s)
- 2021 GT Premium Shadow Black 10spd Auto
I do not. I'll admit I'm a Borla fan, I have had them on so many cars. I had the S Type cat back on my 2019, which was basically 3" straight pipes and it was LOUD. Sounded great though. I added the Switch fire and liked the increase, but the stock mufflers sound metallic when you get on it. I went round and round with axle backs, and after some input, I just decided to mate the Switchfire with the S-type axle back instead of the Roush axle back. Plus this method was much cheaper than the entire S-type cat back.
Glad it sounds good! Picking mine up at lunch from the shop.
Headless Horseman
Well-Known Member
- Joined
- Apr 5, 2021
- Threads
- 29
- Messages
- 377
- Reaction score
- 473
- Location
- Atlanta, Ga
- First Name
- Tim
- Vehicle(s)
- 2020 Mustang GT PP1
Man without the active it's going to be a Grown Man all the time! I only like the active to keep it quiet so people think it's some over modded 6 or 4 cylinder. I notice a lot of Dodge guys put Cats on the side of their cars and theirs no Hell in them! I make Hellcats and ZL1s pissed at the Redlights! Can't wait till your hear it!
Sponsored
