What did you do to your S550 Mustang today?!

[acemastr]

I run 30-32psi on the premium 20" with Michelin PS4S... I'm a bit of a corner addict.

Sponsored

 

[frank s]

Yesterday, Saturday: Granddaughter came by for a distanced visit. Sort of bittersweet. She lives in a different milieu, more likely to contact Covid victims, and since wife and I are both on the vulnerable list, she's here and delightful company, but without the customary hugs and all, not the same. Will things ever be "the same" again?

Meanwhile, back on the "What did you do?" page: Debuted the new shirt. Granddaughter was less than enthusiastic; car rolled its eyes and said, "Yeah, right".

 

[Rippermac]

I reminded myself why I don't like pollen...but on the other hand it means Spring is here and top down driving is at hand!!

 

[WildHorse]

Admired my idle dB

 

[samd1351]

Well, thank you Jennifer at Anchor Room for sending me a new oval.

This time we cut it out and taped it plave, then started to peel off the backing. Went much better.

 

[m3incorp]

Oh man, they actually forgot to install the sensors...that would definitely explain the tool not picking up any sensors installed.

Had to break the wheels and tires down to put in the TPMS sensors that American Muscle "forgot" to install when they sent me my wheel/tire package. Now I'm reading correct pressures and no "low pressure" light. What are yal running? I got 35 in the fronts and 32 in the rears.

 

[m3incorp]

Today I did a wash, clay bar, wash, polish with Black Fire Polish and Seal, and wax. I was going to use my BlackFire Total Paint Protection also but it looks like I must have left it in the hot garage and looked like spoiled milk, so I ended up topping off with a wax. I noticed a lot more paint blemishes than I really wanted to see. I will have to see if the two-step correction can take care of those problems when it is safe enough to get it to the detailer for PPF and Ceramic Coating. I also got around to pulling out the GoPro and getting a couple of videos after adding the Steeda Axle-Backs to the Steeda H-Pipe.

 

[Biggsy]

Put in Schroth Harness.

 

[sabtaj1]

Today I ripped off the stock manifolds, long tubes come tomorrow..... Installed QA1 carbon driveshaft, installed the Steeda rear end add on bushings to compliment all the BMR goodies back there, cut my stainless exhaust tips to modify my stock active exhaust. Tig em on tomorrow n spray em black then header install tomorrow when they arrive

 

[m3incorp]

Thanks

 

[Dusten]

Took my gps and my forscan out to fix my speedo with the summer wheels on. It reads dead on at 80. Im happy

 

[BlueDragon]

Installed BMR SP083 rear springs, FRPP performance shocks, BMR upper rear shock mounts, and BMR CB005.

 

[StangTime]

Installed BMR SP083 rear springs, FRPP performance shocks, BMR upper rear shock mounts, and BMR CB005.

How do you like these mods? Thinking of doing the same thing but using the H&R shock mount instead.

 

[Ceayay]

Dropped it off to get the engine tick looked at. Got handed a Ford service doc about the typewriter tick being a normal characteristic and not detrimental to the engine. Let’s see if they even bother looking at it or check for cylinder scoring

Sponsored