Knockdown
Well-Known Member
- Thread starter
- #1
Just installed these harnesses, they work nice! I got the Mustang 2018-2020 pro sets.
Rear quarter plastic panel push pin locations
Lap belt male adapter
Disclaimer: I’m not sure if this is the correct way to install these, but they’ll hold us in place on track days and we didn’t get any dash warnings.
- Remove rocker panel plastic - lift upwards
- Remove back seat - 2 release latches under center of seats, push reward
- Remove quarter panel plastic - start from rear and work forward
- Remove two 50 torx bolts from bottom belt sensor
- Fit hip belt male adapter to front bolt under sensor
- Put two thick washers underneath sensor for back bolt - not sure this necessary but I wanted to keep similar alignment
- Install shoulder belt male adapter using factory shoulder belt 13mm bolt - I positioned belt pointing to outside of car, 90 degree bend, on top of factory bracket to get max height
- Mark area of plastic and remove plastic on rear quarter panel for lap belt male adapter - I went up from the tether cut out to just below rocker panel bend, 2.1 inches forward down the bend, and then down
- Install rear quarter plastic panel
- Install rocker panel plastic panel
- Repeat for passenger side if required
- Install rear seat
Rear quarter plastic panel push pin locations
Lap belt male adapter
Disclaimer: I’m not sure if this is the correct way to install these, but they’ll hold us in place on track days and we didn’t get any dash warnings.
Sponsored
Last edited: