cprime
Well-Known Member
- Joined
- Aug 30, 2021
- Threads
- 5
- Messages
- 75
- Reaction score
- 173
- Location
- Bucks County, PA
- First Name
- Caelan
- Vehicle(s)
- 2022 Mustang Mach 1
- Thread starter
- #16
Yes it most likely is the cause. I was prepared to pay for a new wire harness if it was necessary because I was aware of this issue from resonator deletes. I wasn’t positive it needed to be replaced when I brought it in and was happy at first when the service manager claimed they fixed the active exhaust issue by resetting the system and clearing the code. I’ve already ordered the wire and will be replacing it myselfThe way they handled the situation definitely leaves something to be desired, however the exhaust install is most likely the cause of the active failure by not cutting back the remaining section enough. This pushes the location of the active solenoids back into the pinch weld. Without bending the rear pinch weld away from the actuator, or trimming the leads going into the X pipe, those wires will wear through again.
Sponsored