Should I do a Built Engine?

[Zrussian13]

Hmm may need bigger injectors then. Even on a very low wastegate spring I think it would be hard not to hit 650.

Very hard. The small hellion wg springs have me sitting at 6lbs of boost on my low setting and i put 667 to the wheels on pump gas.

Sponsored

 

[tdstuart]

Going to see if the shop can clean up my gen2 block. They quoted $2800 for sleeving it which seems a little high

 

[robvas]

Going to see if the shop can clean up my gen2 block. They quoted $2800 for sleeving it which seems a little high

That sounds about right

 

[Timbuck]

Going to see if the shop can clean up my gen2 block. They quoted $2800 for sleeving it which seems a little high

IN your money it cost me $1250 for machining the block and fitting sleeves and $1130 for the darton sleeves. That was Mates rates….

but I do remember looking up costs at the time , and it was around $200 usd per hole at one of the well know shops In the USA + sleeves.

 

[Anyone3505]

Honestly if I were on my 4th engine, i'd just leave it stock and use that money for something I wouldn't break LOL

 

[robvas]

6th one is free if you have the punchcard

 

[tdstuart]

Honestly if I were on my 4th engine, i'd just leave it stock and use that money for something I wouldn't break LOL

Yes this is the sane move. Car keeps telling me to stop modding it

 

[tdstuart]

6th one is free if you have the punchcard

Haha need to ask the machine shop if they have this program as well. Every time the engine has blown up I have gotten the heads inspected, cleaned, and resurfaced if needed.

Sponsored