Lift points?

[Rickkyyr8]

Hey guys, going to be lifting my 500 for the first time. Anything specific I need? Where are the jacking points? Trying to get an idea so I’m not going in blind. Thanks guys

Sponsored

 

[Epiphany]

Owner's manual.

 

[dnstommy]

Hey guys, going to be lifting my 500 for the first time. Anything specific I need? Where are the jacking points? Trying to get an idea so I’m not going in blind. Thanks guys

https://www.steeda.com/2015-2019-mustang-jacking-rails

 

[Cobra99]

get the pinch weld protectors. Something like this(https://zl1addons.com/products/premium-3-inch-pinch-weld-magpad)

 

[Ezatnova]

Steeda jacking rails or other product are your friend. Make life a lot easier. For your first time lifting the car up, before you have them, I'd recommend race ramps and just squeeze under and install the rails.

 

[PoCoBob]

get the pinch weld protectors. Something like this(https://zl1addons.com/products/premium-3-inch-pinch-weld-magpad)

I just use a hockey puck. $4 and you're golden.

 

[Cobra99]

I just use a hockey puck. $4 and you're golden.

Yep did that but it's a PITA. The ones with magnets work better.

 

[beefcake]

Hey guys, going to be lifting my 500 for the first time. Anything specific I need? Where are the jacking points? Trying to get an idea so I’m not going in blind. Thanks guys

Hit me up and I can get you a set of BMR or Steeda Jacking Rails.

They make life super easy and no worries of crushing the OEM pinch weld. Simple mod that a ton of guys look past buy love when they add them!


Feel free to DM me or call with any questions!
Terry "Beefcake" Reeves
- 855-827-7223 -
www.beefcakeracing.com
#beefcakeracing #teambeefcake

 

[stannypack]

front subframe -> 2 jack stands
rear subframe (next to the diff) -> 2 jack stands

tried to do 1 corner at a time but was too sketchy almost tipped a jack stand over

 

[skinnyb]

I also concur regarding the jacking rails. I have a Steeda set and they make life soo much easier. Just grab the rail right in the center and lift the whole side of the car up. I do this when I remove the wheels for deep cleaning or swapping from winter to summer setup.

 

[MAGS1]

Another for Steeda jacking rails. Get the full length ones though not the low profile.

 

[Finally21]

Just installed full length Steeda on my GT350, took less than an hour.

 

[Highoctanecobra]

If you are concerned about the jacking rails rusting, beware of the Steeda.

Their paint/powder coat process does not keep them from rusting.

They will not warranty their rusty jacking rails.

 

[MAGS1]

If you are concerned about the jacking rails rusting, beware of the Steeda.

Their paint/powder coat process does not keep them from rusting.

They will not warranty their rusty jacking rails.

Mine have been through 4 Chicago winters so far and zero rust

 

[Johnny Rockit]

I ordered the Kenny Brown Performance rails. They are a trapezoid shape, galvanized, and have drain slots. On back order for weeks. Will see how long they acrually take to get here.

Sponsored