D1x stage 2 installed!

[TGGT]

Probably going to have to reschedule Wednesday’s Dyno session. Just noticed a small fuel leak from where I soldered in the additional feed tube on my rail. I’ll have to take it off tomorrow after work and then take it to work on Wednesday and hopefully fix it.

Sponsored

 

[TGGT]

Round 2 on the fuel rail mod. So far so good. If it leaks this time I don’t know what I’ll do. I would probably just pony up the dough for the fore rails. Anyway keeping a close eye on it and really I’m trying not to drive it too much until we get time to strap it to the Dyno.

 

[80FoxCoupe]

I'd just plan on Fore rails. If that springs a leak while you are driving, car will be a total loss. That's assuming you are ok.

 

[TGGT]

Drove it to work. No leaks. I’m pretty sure it’s good this time around. Silver soldering is supposed to be just as good as welding if done right so I don’t think there will be any issues with that moving forward. One new problem I did notice is that my alternator is putting out 15 volts. I’m sure this is due to the fact that I ran my fuel pump leads from the back of the alternator. I’ll move them and that should fix that issue.

Sponsored