Vortech install done, flashing CEL

[BKoz]

My new CPS was delivered today, that I install it and it's all good.

Sponsored

 

[BKoz]

CPS in, relearn done, same old flashing CEL code is still p0300:00-64.

Only other thing that was changed besides the supercharger was the fuel injectors and BAP.

 

[2022 Mach 1]

Old gas?

 

[BKoz]

Old gas?

New full tank of 93.... I'm still going to throw some octane booster in next chance I get because, why not at this point. Not really driving it much until I get this figured out.

 

[2022 Mach 1]

I had a bad tank once. Once I went into boost on my 2014 it threw a generic p0300. Drained the tank, cleaned the injectors and I was good. Just a thought.

Log it and sent it over to your tuner for a look.

 

[BKoz]

I had a bad tank once. Once I went into boost on my 2014 it threw a generic p0300. Drained the tank, cleaned the injectors and I was good. Just a thought.

Log it and sent it over to your tuner for a look.

Would be so happy if that's the case.

 

[BKoz]

Filled up with 93 and added a bottle of octane booster. A bunch of hard pulls and no CEL. Last one was from a very low speed and after two gears I get the flashing CEL.

This place that I pull out and get to floor it from a low speed start.... It's almost a guarantee the CEL will happen.

 

[mitsuchris]

have you talked to the tuner? I gapped the plugs to 25.

 

[Jackson1320]

what injectors and what bap? i think i would try to close the gap on the plugs a little more.

 

[BKoz]

Injectors and BAP are from the vortech complete kit.

Working to get logs to the tuner.

 

[BKoz]

The instructions for the kit don't say to change the plugs. Is it possible that the tune works better with closer to stock gap?

 

[kenand1988]

The instructions for the kit don't say to change the plugs. Is it possible that the tune works better with closer to stock gap?

Do you know what boost its supposed to hit?

 

[BKoz]

Do you know what boost its supposed to hit?

7.5-8.5psi

 

[Rothgray]

I ran .022 gap on 6510's with my Vortech setup when I had my 2019 GT

 

[kenand1988]

7.5-8.5psi

You really shouldn't need a tight gap for that amount. Id do. 025-. 028

Sponsored