grumblin
Well-Known Member
- Joined
- Jan 26, 2015
- Threads
- 12
- Messages
- 196
- Reaction score
- 72
- Location
- Carrollton, TX
- Vehicle(s)
- 2015 Magnetic GT Premium
For solder-phobics like me, i'm going to try something a little different for attaching the wires to the molex connectors. I'm going to try two separate methods:
1) I ordered a simple 2x8 IDC female/female ribbon cable as a wire break-out for the line-outs. I'm going to see if I can get it in the body on the headers.
2) I also ordered one of these: https://www.adafruit.com/products/266 - it's looks easier to use as a breakout for the RCA's but the single connectors could cause it to come apart easier.
Neither will work for the speaker connectors as the wires are much too small - but dang, trying to fit AWG16 wire on those pins is a bear.
1) I ordered a simple 2x8 IDC female/female ribbon cable as a wire break-out for the line-outs. I'm going to see if I can get it in the body on the headers.
2) I also ordered one of these: https://www.adafruit.com/products/266 - it's looks easier to use as a breakout for the RCA's but the single connectors could cause it to come apart easier.
Neither will work for the speaker connectors as the wires are much too small - but dang, trying to fit AWG16 wire on those pins is a bear.
Sponsored