Process's Procharged D1SC Stage 2 project

[Grimace427]

Do you have billet oil pump gears? If not, I'd do that before adding any more power.

Sponsored

 

[Process]

Do you have billet oil pump gears? If not, I'd do that before adding any more power.

Where they are a good mod to have, and are on my list, pump gears break with excessive rpm, I'm spinning to 7200.

 

[Grimace427]

Where they are a good mod to have, and are on my list, pump gears break with excessive rpm, I'm spinning to 7200.

That hasn't been definitely proven. Guys have been breaking them at 7,000rpm just as often as higher rpm's.

 

[Process]

Show me. I've only seen them bust at around 7700+ under boost. Especially guys running two steps.

 

[S550 KID]

Nice, what pulley and boost psi?

 

[Process]

Stage 2 crank and 4.385. 15psi

 

[Grimace427]

Show me. I've only seen them bust at around 7700+ under boost. Especially guys running two steps.

Ken Bjonnes broke at least one oil pump testing his TT setup at the strip, claimed 7,000rpm redline. Kenne Bell said they broke oil pumps due to crank harmonics when they were testing various pulleys. Said they fixed the issue with a new crank damper/pulley(in addition to billet gears). That was back in late 2010/early 2011.


Not trying to argue with you, just don't want to see you lose an engine with that power number because of the stock oil pump.

 

[Process]

It'll get replaced. Just not at the moment.

 

[Grimace427]

Also Kelly Aiken(BMR) highly recommends the ATI Super Damper along with the OPG with high HP blower setups. I think that's what Kenne Bell ended up using but not 100% sure on that.

http://www.mustang6g.com/forums/showthread.php?t=10651&page=4

 

[Process]

Also Kelly Aiken(BMR) highly recommends the ATI Super Damper along with the OPG with high HP blower setups. I think that's what Kenne Bell ended up using but not 100% sure on that.

http://www.mustang6g.com/forums/showthread.php?t=10651&page=4

I'm running the procharger stage 2 setup, can't run a different dampener. Unless their is something that has been released that is compatible.

 

[Process]

RIP clutch

 

[phunk]

RIP clutch

Well damn... makes me feel better about ordering a RXT today.

What do you plan to replace it with?

 

[Process]

Well damn... makes me feel better about ordering a RXT today.

What do you plan to replace it with?

same as what you bought. Hopefully itll arrive soon.

I was out for some spirited fun, and lost the clutch. Can put the car into gear and completely walk away from the car and it wont stall. Wreaked of clutch. Had to flatbed it home.

 

[phunk]

Sorry to hear that... Towing sucks. Yup, guess I need to put this in immediately.

 

[Process]

McLeod RXT and Steel flywheel on the way, as well as a new shifter.

Sponsored