New IT Mod Everyone Must Do

[BullittTheBlueSky]

Three words;

Epoxy coated.
Marine.
Battery Cable Terminals.

The negative battery terminal/post turns into a corrosion encrusted Christmas tree over time. Duralast makes epoxy coated marine battery cable terminals for just such an occasion. Now........I just installed it, so I have absolutely no idea if it will actually do anything about corrosion. But it's only $13, is the easiest things to install ever, and looks cool.

Why? Battery I replaced last October guano'd the bed. Starting had become intermittent and hard the last few months. Jumped the car and drove to Vato Zone, figuring the battery was bad. Turns out that it was the negative battery cable terminal not making proper contact with the post, so the battery wasn't getting charged properly. And my voltage reading was a constant 14 volts, no variation at all.

So for $13, and 30 minutes of sweating in this awful heat and humidity, I got a new battery and a Duralast Epoxy Coated Marine Terminal installed. And suddenly I could see the alternator varying it's output from the volt gauge.

Enjoy. It's cheap and something to do.

Sponsored

 

[Unbridled5.0]

I swear I read the first sentence and instantly knew you were from Florida. Lmao.

Glad you got it sorted out.

 

[WItoTX]

That's way more than three words.

But duly noted!

 

[BEERCHAMP]

and looks cool.

Where are the pics?

 

[Joe Gonsalves]

I've been using the anti-corrosion felt washer on the battery posts on several cars for quite some time and it prevents the corrosion quite well. And they are super cheap $2.

 

[BullittTheBlueSky]

and looks cool.

Where are the pics?

Duralast Screw Battery Terminal DL06071 | AutoZone

 

[BullittTheBlueSky]

I've been using the anti-corrosion felt washer on the battery posts on several cars for quite some time and it prevents the corrosion quite well. And they are super cheap $2.

Something I learned today.

The bottom of the cable terminal is meant to touch the bottom of the battery post where it's molded into the plastic of the battery body.

On the face of it, those felt pads would stop that part of the electrical connection.......but......hell, if it works for you.

I dunno.

 

[Joe Gonsalves]

Something I learned today.

The bottom of the cable terminal is meant to touch the bottom of the battery post where it's molded into the plastic of the battery body.

On the face of it, those felt pads would stop that part of the electrical connection.......but......hell, if it works for you.

I dunno.

Agreed, however those surfaces are not in compression. If the battery cable clamped down then yes, but it's clamped around the post. There is no guarantee that the mating surfaces are held tightly enough to matter. Once corrosion starts under the clamp then all bets are off.

 

[HKusp]

Duralast Screw Battery Terminal DL06071 | AutoZone

Pics on YOUR car or it didn't happen...

 

[Pistol_91]

Vato zone got a good chuckle out of me lol

Sponsored