Brad
Owner
Over an already tuned car 10-20whp on a mostly stock setup.With the proper tune on meth injection what kind of gains are expected? Also, how difficult of a DIY is the install of a meth injection kit?
Sponsored
Over an already tuned car 10-20whp on a mostly stock setup.With the proper tune on meth injection what kind of gains are expected? Also, how difficult of a DIY is the install of a meth injection kit?
AFAIK, you don't need to use any particular octane with meth injection. Meth raises the octane of whatever gas you use and, depending on how much meth you inject, you should be able to calculate the final resulting octane of the air fuel mix. You just have to make sure that when you get tuned, you get tuned for the resulting octane.When I mentioned adding a meth kit I was told I'd have to use 93 octane to run meth injection. Why is that?
Anthony, are you running meth or water-meth. My understanding is that most everyone recommends not exceeding a 50-50 mix of water and meth because of the volatility of any mix with a higher ration of meth.Yeah I thought about it for awhile.
It's actually ideal to put it in the left back corner for better balance.
Also I don't want 2 gallons of meth near the front of the car. "Boom, boom" lol
Over an already tuned car 10-20whp on a mostly stock setup.
I was under the assumption e30 is 20-30hp gain. Certainly feels like it to me when I go from 93 to e30
Ya don't say..........:lol:Yeah I thought about it for awhile.
It's actually ideal to put it in the left back corner for better balance.
Also I don't want 2 gallons of meth near the front of the car. "Boom, boom" lol
Lol that takes guts!Ya don't say..........:lol:
I gained 40+I was under the assumption e30 is 20-30hp gain. Certainly feels like it to me when I go from 93 to e30
100% methAnthony, are you running meth or water-meth. My understanding is that most everyone recommends not exceeding a 50-50 mix of water and meth because of the volatility of any mix with a higher ration of meth.
I have mine injecting pre intercooler to help with charge temps.So where did you guys decide to inject? I've been contemplating this for a while... And multipoint or single. I've been considering the boomba manifold spacer or mishimoto charge pipes so I don't have to mod.stock parts. If there are other aftermarket options I'm open to suggestions.
Sorry for the noob question but what consequence could I expect to see from injecting pre intercooler? There seems to be a vast and varied opinion on the matter. I would think that moisture in the intercooler long term would be bad. I want to run meth primarily for aid in cleaning the head and cooling in my daily driver. HP and/or fuel economy gains are simply a plus.I have mine injecting pre intercooler to help with charge temps.
You can do it at the throttle body if you wish though.