Anderson Composites

[AMBJR]

That one may be a bit sooner since we would be making our own version from the Ford piece and not sell exclusive.

What about the HOOD!!!

 

[Anderson Composites]

What about the HOOD!!!

I would estimate 10-12 weeks for the hood. Please place an order through one of our authorized dealers to get on the list.
https://andersoncomposites.com/pages/dealer-locator

 

[NEUMAN]

Anyone have any updates for the Ford Performance/Anderson Composites parts?

 

[chill66]

Does anyone know the process to replace the front bumper cover (the black painted part)? If I were to swap out for a carbon fiber one, does that require removing the entire front bumper assembly?

 

[Tomster]

which ones?

Does anyone know the process to replace the front bumper cover (the black painted part)? If I were to swap out for a carbon fiber one, does that require removing the entire front bumper assembly?

I dont know exactly, but even if you did, its not a big deal.

 

[chill66]

which ones?

I dont know exactly, but even if you did, its not a big deal.

Is it not? With all the cooler ducting, etc?

 

[Tomster]

Is it not? With all the cooler ducting, etc?

No, the front bumper fascia is just that, a cover. It comes off with a few screws here and there.

 

[Tomster]

^^^ I dont have the GT500 manual, but I can't imagine it is too different than the 350.

 

[chill66]

No, the front bumper fascia is just that, a cover. It comes off with a few screws here and there.

Don’t have to pull the front bumper to access those screws? Maybe just pull the splitter to access up from underneath to get to the backside?

 

[Tomster]

Don’t have to pull the front bumper to access those screws? Maybe just pull the splitter to access up from underneath to get to the backside?

IIRC, remove screws along top of cover where the hood closes, the bottom splitter, and in the wheel well. The pain in the ass were the two side screws just aft of the headlight. Thats it. Just disconnect the turn signal wiring etc

 

[obspsd]

Does anyone know the process to replace the front bumper cover (the black painted part)? If I were to swap out for a carbon fiber one, does that require removing the entire front bumper assembly?

I am quite sure you have to remove the whole bumper.

 

[Epiphany]

IIRC, remove screws along top of cover where the hood closes, the bottom splitter, and in the wheel well. The pain in the ass were the two side screws just aft of the headlight. Thats it. Just disconnect the turn signal wiring etc

This.

 

[chill66]

I am quite sure you have to remove the whole bumper.

That’s what I was thinking too.

 

[Tomster]

Its a fascia. Its a molded piece of ABS plastic.

 

[Bootsyy]

First Anderson Composite piece install swing and gurney flap

That looks incredible and your GT500 is gorgeous! I'm hoping to get myself one of those or a GT350 someday... I'm a little late to this party but I am planning on getting the swing soon for my GT. Just wondering if you had to get a clear coat applied or anything to prevent yellowing? I'm reading conflicting information about what to do with new carbon fiber all over the place. So any info would be much appreciated!