AMBJR
Well-Known Member
What about the HOOD!!!That one may be a bit sooner since we would be making our own version from the Ford piece and not sell exclusive.
What about the HOOD!!!That one may be a bit sooner since we would be making our own version from the Ford piece and not sell exclusive.
I would estimate 10-12 weeks for the hood. Please place an order through one of our authorized dealers to get on the list.What about the HOOD!!!
I dont know exactly, but even if you did, its not a big deal.Does anyone know the process to replace the front bumper cover (the black painted part)? If I were to swap out for a carbon fiber one, does that require removing the entire front bumper assembly?
Is it not? With all the cooler ducting, etc?which ones?
I dont know exactly, but even if you did, its not a big deal.
No, the front bumper fascia is just that, a cover. It comes off with a few screws here and there.Is it not? With all the cooler ducting, etc?
Don’t have to pull the front bumper to access those screws? Maybe just pull the splitter to access up from underneath to get to the backside?No, the front bumper fascia is just that, a cover. It comes off with a few screws here and there.
IIRC, remove screws along top of cover where the hood closes, the bottom splitter, and in the wheel well. The pain in the ass were the two side screws just aft of the headlight. Thats it. Just disconnect the turn signal wiring etcDon’t have to pull the front bumper to access those screws? Maybe just pull the splitter to access up from underneath to get to the backside?
I am quite sure you have to remove the whole bumper.Does anyone know the process to replace the front bumper cover (the black painted part)? If I were to swap out for a carbon fiber one, does that require removing the entire front bumper assembly?
This.IIRC, remove screws along top of cover where the hood closes, the bottom splitter, and in the wheel well. The pain in the ass were the two side screws just aft of the headlight. Thats it. Just disconnect the turn signal wiring etc
That’s what I was thinking too.I am quite sure you have to remove the whole bumper.
That looks incredible and your GT500 is gorgeous! I'm hoping to get myself one of those or a GT350 someday... I'm a little late to this party but I am planning on getting the swing soon for my GT. Just wondering if you had to get a clear coat applied or anything to prevent yellowing? I'm reading conflicting information about what to do with new carbon fiber all over the place. So any info would be much appreciated!First Anderson Composite piece install swing and gurney flap