Did you have a chance to install these? I'm considering doing this hood for my Mach 1 with a new emblem done around the vent. I wanted to do the Quick-Latch system as well but I can't seem to find an answer on where these mount on the inside. If you do have it installed, can you show a picture of what it looks like under the hood?
I haven’t installed em as of yet. Weather hasn’t cooperated yet to get the car out of storage
I've been scanning through the 5 pages of stuff but can't seem to find all the info.Got some good pics today of my car!
She looks great man!!!!
Well, I used my own hardware to mount the vent to the hood. It’s pretty trick. And where the raintray mounts I used rivet nuts and attached them to the vent and have knurled finger screws to take the rain tray off n on with ease if needed when washing or if rain may be coming when out. I’m running the BMR drag springs and it’s the PP1 with the lower piece from eBay that was like 115$ shipped. The one piece lip.
yea, the Vicrez hood has those bends, but they’re really unnoticeable under decals. I was worried about that too with my GT500 stripes, but after they were put on, you really can’t tell at all.
I may just go for it anyway because I really like the hood and it should also eliminate any sort of flutter at high speeds which is one downside of the 2018 hood with no real vents. I think the OEM Mach 1 decal can still work.
Are these Big Worm? If so are they narrow or wide?
I think they look great! Surely there must be a page on the internet with the specs fo the GT500 stripes? "Thou dost have stripes that are only X inches in width and Y inches apart. Not more and not less"
