Looks good and professional, can you post more photos.Direct wired my Uniden R3 Radar Detector to the back of the mirror, way too easy. The mirror mount/wiring came with two additional "round " wire extensions that fit into the brown/yellow hot and blue ground at the back of the mirror.
White residue is usually not a good thing, indicative of corrosion or carbon tracking. Did any of the ceramic portions of the plug have a strange line etched into them? If the car is running fine I wouldn't worry about it, but a good clean and some dielectric grease on the inside of the coil boot wouldn't be a bad idea.I mean I’m leaving my full suspension etc.
My concern is randomly my afr goes everywhere.
Ie. Cruising 60mph cruise control flat land
Goes from steady 14afr to 12-15-12-16-12-15-12-16 for like 5-10 seconds
I cannot recall it happening before the downpipe
Once I removed downpipe I still had it, so chef sent me a used o2 sensor, mine vs his.
My logic is if the o2 sensor was this dirty maybe a new set of plugs would benefit. I just pulled plugs and they look fine I thinks but I am tossing new ones in anyway since already got them out
What’s with the white stuff on bottom or coil packs? Normal?
Edit just checked all 4 plugs gap, exact same gap as the 0.028 I gapped them too originally. So they held up to the increased boost from downpipe like a charm
This little gadget from China and feeler guage works great!
@JohnnyGT Diffuser pics?Got the spoiler and rear diffuser installed after work.
Need to wait till tomorrow to get better pics of the diffuser.
I also bought gas. Filled up with BP 93 for $3.00/gallon. Damn.
thanks, did a detail cleaning yesterday and waxed, should have taken more pics. It is under the cover in the garage now awaiting better weather before it goes out again.
In between the two holes is fine.Hey guys; I had my car on a lift to do downpipe awhile back, I did an oil change beforehand and when it was on lift I noticed oil beaded up on oil filter
I thought it was maybe leaking, so I removed filter, inspected gasket and put it back on. I lost some oil. Not sure how much
So everyday I’ve been adding like a little bit of oil. I was adding to fill to the top of hash marks completely cold.
So everyday I have inspected, this is a 4th of quart added over a week.
I have a hard time feeling like I lost half a quart of oil.
When I did oil change I did exactly 5.7 quarts (17 ecoboost)
Is the top of hash supposed to be touching or am I supposed to be in middle of the hash area cold?
The manual just says, if it’s below the bottom hole add lol.
Should I leave it as is?
I’ve never removed an oil filter before before an change. I don’t think it was leaking, I think it was just residual oil from previous change on bottom of filter.
Well, taint you funny!
Gooch jokes are a perineal favorite.
Potato phone with an Ebay telephoto lens.
