What did you do to your S550 Mustang today?!

[Osofast]

Installed the Pedal Commander! It should have come from the factory like this...! I use Sport 4, and it’s FANTASTIC! Everyone needs this, not having one on a Mustang is just silly...

Put one on my 18gt w/A10 and it was awesome for the first couple of weeks, then it started shifting really strange, IE. not holding a gear long enough, searching for a gear, really erratic issues. The moment I removed it all went back to normal.
Like to hear an update from you in a little while if it’s still working out, as it definitely improved throttle response

Sponsored

 

[turnswrench]

Change the look 15” rear 275/60 17” front

Knuckles?

 

[bigwill90]

Knuckles?

No it’s the 9.33 wide...Wheel was designed for S550

 

[GMONSTAH]

Car wash after a more than a week of rain...

 

[GMONSTAH]

Also installing clear vinyl headlight and fog light protection film.

 

[sw686blue]

Added the GT350 red start button and Roush heat extractors to my baby!

 

[sw686blue]

And tomorrow I'll install my Big Worm taillight and reflector tints.

 

[Clump]

Pulled the wheels, cleaned everything and replaced factory lugs with Gorilla chrome lugs and locks.

 

[StangTime]

Tried removing the sound tube. That SOB won't come off. Got the one end off the intake no problem and got the fitting out of the hole in the firewall. But no matter how hard I twisted and pulled I couldn't get the plastic to break free off the stud. I have the PP1 and the firewall brace is limiting my leverage. So I now need to remove the nut from the stud or go at it from under the car. Will try again tomorrow. The swear jar is full.

 

[Stone pony]

Started installing sound deadening. Sure hope it helps.....

 

[PKs]

Started installing sound deadening. Sure hope it helps.....

I did that last weekend and found the already tight fit spare would not fit down far enough into the well. I removed from the vertical edges and just left the base covered.

 

[2017GBGTPP]

I locked down my shifter and now I'm ready to Full Tilt Boogie!

 

[DFB5.0]

A clean Mustang and sunny Sunday mornings are a match made in heaven.

 

[robertwsimpson]

Tried removing the sound tube. That SOB won't come off. Got the one end off the intake no problem and got the fitting out of the hole in the firewall. But no matter how hard I twisted and pulled I couldn't get the plastic to break free off the stud. I have the PP1 and the firewall brace is limiting my leverage. So I now need to remove the nut from the stud or go at it from under the car. Will try again tomorrow. The swear jar is full.

told you.

 

[2morrow]

Got this project started. Not totally done but will be soon.

Sponsored