What did you do to your S550 Mustang today?!

[1crazymach]

Here's a couple more pictures.

Sponsored

 

[2morrow]

Here's a couple more pictures.

Looks great!

 

[car]

Installed the Krona cat back on my GT tonight, jack stands in the rear and wheel chocks up front.

2400 miles in winter weather since I bought it in December. I've been very careful about salt and car washes. The underside looks pretty clean except for the driveshaft, damn thing was the only thing with rust. You can't really see it in the second pic, but there's surface rush on every part.

Just paint it with a anti rust mixture. Then when dry black paint.

 

[Mustang530]

Here you go

Those look really nice! Big fan of those

 

[gameovergt]

ordered 2018 GT intake. Now trying to decide on tuner.

 

[Joelang33]

Here's a couple more pictures.

Ford getting damn good at creating OEM wheels that are actually cool :ford:

 

[mcbagpiper]

Finally installed some tint on my rear lights. I had ordered a kit from ebay but the film was crap, it wouldn't conform to the lights properly and ended up creasing in several places. I decided to just order some higher quality tint (2x5' roll) and cut my own pieces. The new film was so much better, easy to work with and didn't trap air or create wrinkles. It's nice to order pre-cut, but you never know the quality of the product being used.

Car goes in tomorrow for an alignment after installing BMR lowering springs over the winter, can't wait to finally drive it again!

 

[2015DIBGT]

Ordered the RTR side splitters and rear spats.
Grabbed the camera to take a few shots.

 

[Brian_S550]

To celebrate Mustang Day, I just finished swapping out the original trunklid panel on my ‘15 coupe for one that I’ve customized. I started with a Ford Racing 2018 badge-delete panel and added an S197-style faux fuel cap badge that I found recently. I really like how this looks on the S550... it looks sort of like the European market Mustang’s design.

 

[HISSMAN]

Your camera was upside down.

 

[Loki-GT]

Fixed.

 

[AMChief5.0]

Here you go

Have pics of these installed yet? I'm assuming these are the FMS PP2 wheels?

 

[Fatguy]

To celebrate Mustang Day, I just finished swapping out the original trunklid panel on my ‘15 coupe for one that I’ve customized. I started with a Ford Racing 2018 badge-delete panel and added an S197-style faux fuel cap badge that I found recently. I really like how this looks on the S550... it looks sort of like the European market Mustang’s design.

Cool. I hated the badging at first but it’s grown on me so mine stays stock.

 

[dprdmd]

tint

Had my FRPP sport (Borla) cat-back exhaust done before the winter. Finally Spring has arrived and I just got the tint done.

 

[Houston Kid]

Finally got around to adjusting the exhaust. I am now an expert at taking Corsa axle back exhaust off.

Installed the Steed front sway bar. Not nearly as difficult as reading some posts as you would think. You have to think of the bar as being U shaped. Pull and turn, pull and turn. I did it by myself and when the factory bar is finally out it is under the car facing the passenger side. I removed it from the driver's side behind the rotor. I started the new bar from the same position and pushed and turned, pushed and turned. Slid right in.

I also found this little white plastic clip when I jacked up the car. It feel out from the plastic pieced the runs between the tires under the door. It feel from between the pinch weld and the plastic.

Anyone know what is about to come loose?

Sponsored