What did you do to your S550 Mustang today?!

[GTP]

Adjusted the exhaust as much as I could. It is still 1/3 off center. To the muffler shop tomorrow. I did not feel like dropping it to bend hangers.

My experience with muffler shops is that I would give them a grade of 'C'. They are unpredictable. They take a torch to your hanger, over-bend it, and eventually give up. Your alignment will still be off, just is a different direction. :lol:

Take a 2' length of 1/2" iron pipe from the home improvement store, and bend the hanger yourself, no torch needed. You can actually use a tape measure to check how far it is off, and therefore, where to move the hanger to.

Just MHO.

:cheers:

Sponsored

 

[Houston Kid]

Alignment after stop the hop install. It recommends doing one and I can see why. I had it aligned last week after spring install and it was perfect.

Some adjustment was needed to get back into spec.

 

[xmustangx]

Eibachs installed full BMR rear kit installed. Alignment done. Waiting on valve stems to install my wheels.

 

[GTRacerX.]

Put some more miles on her ...

Since 07/03/17 when I picked her up.

 

[dogiebitt]

Cleaned out my personal belongings before her extended stay at the dealership for valve issues...
https://www.mustang6g.com/forums/showthread.php?t=100632

 

[AppoTheApple]

Installed my new hood yesterday and gave it a wash today. Life is good.

Edit: I guess I can't upload from imgur so here's the direct link https://i.imgur.com/qXJsPXT.jpg =(

 

[Deeplakes]

Sadness is installing Performance Pack 2 and it rains all day

 

[z06psi]

Installed my new hood yesterday and gave it a wash today. Life is good.

Edit: I guess I can't upload from imgur so here's the direct link https://i.imgur.com/qXJsPXT.jpg =(

Fail.

 

[GT Pony]

Need to refresh the browser when it's jumped to imgur for the photo to show up.

 

[Dare2goBare]

Sadness is installing Performance Pack 2 and it rains all day

Ya I hear Ya, detailed the other day for a nice ride , and then it rained, seems this is all were getting here on the WET Coast theses dsys!
Looking forward to your review on the PP2. Shold feel a lot more snap me Thinks. Lol..

 

[Dare2goBare]

Snagged theses babies from p411mstang the other day. Yesterday
Preped one of the two replacement heat extractors for Gloss Black paint.
I'm going to attempt to paint the honeycomb grill Ruby Red, could be kinda tricky, so we'll see. TBD!

 

[DukeGaGa]

Upgraded two 2018 Mustang GT to the latest Sync 3 v3.0 build 18025.

 

[Nagare]

Snagged theses babies from p411mstang the other day. Yesterday
Preped one of the two replacement heat extractors for Gloss Black paint.
I'm going to attempt to paint the honeycomb grill Ruby Red, could be kinda tricky, so we'll see. TBD!

I think it would look neat and nobody but you would ever really notice it if it turns out tacky.

 

[gameovergt]

trying to decide on BMR or Steeda drag springs.

Sponsored