- Joined
- Nov 3, 2016
- Threads
- 27
- Messages
- 1,241
- Reaction score
- 993
- Location
- Ontario, Canada
- Vehicle(s)
- 2015 Race Red Mustang GT
- Thread starter
- Banned
- #1
If you ride, have ridden or are looking to start come on in! Lets see some pics of your bikes with some recommendations on newer ones ect. Let's make this thread good!
I have a 2003 CR250 that I have totally rebuilt from the ground up. Runs on a 50/50 mix of Leaded VP C12 / 91 Ethanol Free pump
Totally rebuilt Engine
- New crank assembly from a 2007 CR250
- New OEM cylinder head
- New waterpump
- All bearings replaced
- Powervalve cleaned and polished
- Wiseco Forged clutch basket and clutch plates
- New OEM honda clutch hub and pressure plate
- Boyesen Rad Valve
- 2000 CR250 Keihein Air Striker Carb with JD Jetting kit
Replaced wiring harness
FMF Gnarly Pipe & FMF Q stealth Silencer
Michelin Starcross Medium Tires
Renthal Chain and sprockets
Protaper handlebars
Black Araii Rims
New wave rotors with pads and new caliper hardware
Rebuilt rear shock and changed oil
Front Fork seals and new oil
New linkage, swingarm, wheel and shock bearing
Oversized Rads w/ rad guards
Blacked out plastics
MX Bonez airbox seal
Tusk rim with an 8 Paddle tire with its own rotor and sprocket for quick change overs to dune mode
I'm sure I left some stuff out as I literally went through the bike bolt by bolt, but that's the meat of it.
I have a 2003 CR250 that I have totally rebuilt from the ground up. Runs on a 50/50 mix of Leaded VP C12 / 91 Ethanol Free pump
Totally rebuilt Engine
- New crank assembly from a 2007 CR250
- New OEM cylinder head
- New waterpump
- All bearings replaced
- Powervalve cleaned and polished
- Wiseco Forged clutch basket and clutch plates
- New OEM honda clutch hub and pressure plate
- Boyesen Rad Valve
- 2000 CR250 Keihein Air Striker Carb with JD Jetting kit
Replaced wiring harness
FMF Gnarly Pipe & FMF Q stealth Silencer
Michelin Starcross Medium Tires
Renthal Chain and sprockets
Protaper handlebars
Black Araii Rims
New wave rotors with pads and new caliper hardware
Rebuilt rear shock and changed oil
Front Fork seals and new oil
New linkage, swingarm, wheel and shock bearing
Oversized Rads w/ rad guards
Blacked out plastics
MX Bonez airbox seal
Tusk rim with an 8 Paddle tire with its own rotor and sprocket for quick change overs to dune mode
I'm sure I left some stuff out as I literally went through the bike bolt by bolt, but that's the meat of it.
Sponsored