Interesting to hear, thanks for adding that. And that is more or less what I am running into. If I drive around and don't get into boost, I don't have any issues. But if I get the car into boost and the meth system activates, then I run into issues.Make sure your nozzles and fittings are solid and not leaking. I was running a 10gph nozzle with no issues. I added a second 4gph nozzle and started having the same issue as you. I tested everything and couldn't find a leak but if I looked at my engine right after making a few hard runs I would find some red stains on the cylinder head around my meth system. It wasn't leaking unless I was hitting full boost. I couldnt pressurize the system enough to recreate the leak without the engine running at least 7lbs of boost so I don't know which fitting in the dual nozzle set up was the issue. I pulled it off and went back to the single 10gph nozzle and no issues. All the fittings and lines look good so my guess is one of the nozzles got bumped and turned a little breaking the seal with the E6000 silicone and that's what was causing it but I'm really only speculating.
Are you using anything on the threaded connections? My snow kit came with this...Interesting to hear, thanks for adding that. And that is more or less what I am running into. If I drive around and don't get into boost, I don't have any issues. But if I get the car into boost and the meth system activates, then I run into issues.
I've taken them all on and off so many times now that I feel like at least one of the times I would have gotten lucky with a perfect seal haha. Definitely worth another check though.
Yep, I have become too familiar with that stuff. But good call on the dry time, I may need to try giving it a bit more time. Its been so hot here lately that it seems to dry within 30 minutes, but it probably takes a bit longer than that for full cure.Are you using anything on the threaded connections? My snow kit came with this...
It takes a while to dry though so I found it best to install all the threaded connections with this and let it sit over night before hooking everything else up.
Yeah it's been crazy hot here lately too. When I re-did my set up I noticed it was pretty dry with in the hour but I let it sit over night anyway and by morning it's rock solid unless you break the bond free. One of these days I'll probably try to go to dual nozzles again and see if that was my issue. I run so much boostane the meth really isn't needed on my set up for anything more than cooling though so I may just call it good enough.Yep, I have become too familiar with that stuff. But good call on the dry time, I may need to try giving it a bit more time. Its been so hot here lately that it seems to dry within 30 minutes, but it probably takes a bit longer than that for full cure.