Zelek
Well-Known Member
Yeah, you'd have to get that one planed unfortunately. That's the first thing I'm going to check before I get it ceramic coated.Mine were warped by more than a 1/4 inch... the replacement was even warped.
![]()
Sponsored
Yeah, you'd have to get that one planed unfortunately. That's the first thing I'm going to check before I get it ceramic coated.Mine were warped by more than a 1/4 inch... the replacement was even warped.
![]()
you'd have to remove too much material though.Yeah, you'd have to get that one planed unfortunately. That's the first thing I'm going to check before I get it ceramic coated.
Yeah, it's a crapshoot at this price point. If you get manifolds that fit well, you're gold with the single kit. The rest of it is much easier to install than the twin kit. I definitely have my concerns with some of the stuff but I also didn't want to spend $12,000 on a Hellion twin top mount.you'd have to remove too much material though.
No pride in their product !
Pity as on3 could do well with just a bit more effort.
Yeah, you'd have to get that one planed unfortunately. That's the first thing I'm going to check before I get it ceramic coated.
Nah that one was too far gone. They swapped it out. I have a mill but that one after milling would have left no more flange.You should be able to get that milled flat without issue. Plus with the MLS gaskets, you'll be fine.
Sounds about rightPurchased my on3 single kit on Feb 14th, Was told a month later a few days ago on March 15th that my kit was still 5-6 weeks out...
I thought you had a hellion setup?Purchased my on3 single kit on Feb 14th, Was told a month later a few days ago on March 15th that my kit was still 5-6 weeks out...