NightmareMoon's latest activity

Feel free to search the forms but I feel like I’ve seen more issues (tolerances, breaking, etc.) from aftermarket OPGs than I have from...

I've only recently started to clean engine bays on my vehicles, but yeah the engine can get properly wet and its fine. Most of the...

Ringworm can be cured by 2-4 week course of an antifungal cream.

Have a ZL1 front and rear hook on mine and I had to use it to get the car on a trailer on Saturday :facepalm:

I have 19x10” P6GR Seven street wheels so you obviously have great tastes, but 8 year old NT05s are probably ice skates. You’re not...

Yeah it died doing what it loved. Put down a good run with power but was rod knocking as we exited the finish chute. I'll take the...

this…times eleventy!

I had a problem with the carpet trim panel just forward of that removable piece which I fixed with velcro. But that thing still gets...

Get a Gen3 block (and oil pan to add capacity), build it out to your specs with ARP hardware, pistons and rods of your choice. Massage...

Did my first string alignment after installing a few STEEDA parts. I’ll need to make a few minor adjustments but overall it turned ”ok”...

If you're running wider than 255 tires, those air curtain holes aren't helping, but they're going to be pretty minor. Why do we think...

Go to AJ Hartmans channel on YT, grab a beer, or 6, and watch his wind tunnel videos, and the CFD data he provides. I am surprised by...

You’re picking up the right takeways. You've done so much to make the handling sharp with all of those bearings, it would b a shame to...

I've never found the dash reading to be off by much if at all.

Just to build on Mags comment. When I brought my 350 home new from the dealer, it tram lined. After about a month or so of tolerating...