What did you do to your S550 Mustang today?!

[Tang]

Haven't done it yet, but going to this weekend. I noticed earlier in the week my turn signal light popped out and is just laying in the light housing. Hopefully I'll be able to get to it through the wheel well and not have to take the bumper off. I have one of these so I'm optimistic

I've done that at least 4 times. I use duct tape and chopsticks. I've gotten pretty quick can do it in about 5 minutes per side with just pulling the fender liners back. Shitty fit on the bulb to socket connection.

Sponsored

 

[CharlesPoole7]

Tried to figure out if the 2k rattle is getting worse or if I am just getting crazier.

 

[The Spider House]

Tried to figure out if the 2k rattle is getting worse or if I am just getting crazier.

Chances are a bit of both?

 

[CharlesPoole7]

Chances are a bit of both?

No doubt. Lost a piece of sanity after going for the s550 after a life of newer Japanese cars.

 

[The Spider House]

No doubt. Lost a piece of sanity after going for the s550 after a life of newer Japanese cars.

Yeah but I bet you get more delight from the stang tho.

 

[CharlesPoole7]

Yeah but I bet you get more delight from the stang tho.

Oh you have noooo idea

 

[MyStang]

The Sun came out today. Another 90 days and the good times will roll.

 

[LCK22GT]

The Sun came out today. Another 90 days and the good times will roll.

I had the same thought today. Then I sprayed another dose of mice repellent around the bottom perimeter.

 

[Jpump]

Went to a Dyno Night last night. Made less than I was hoping for. Made 595/505 on a dyno jet.

 

[vinny89gt]

Went to a Dyno Night last night. Made less than I was hoping for. Made 595/505 on a dyno jet.

I don't see many set ups with the 125mm pulley. What were you expecting too make?

 

[Jpump]

I don't see many set ups with the 125mm pulley. What were you expecting too make?

I was hoping for 600-630.

 

[1 old racer]

I purchased my PP1 in Feb 2018 and by March I installed my 2nd mod., Hood struts(first were jacking rails). Over the years the hood struts have been getting weaker and weaker with out me being much aware of the process til my hood came to visit the back of my head. So I got a new set and WOW what a difference. I have forgotten how hood struts should work. For those who don't have them you don't know how nice it is to open without any effort. For those that have and are putting extra effort in the hood opening process, trust me replace them, fall in love with your hood again.

 

[Boosted Pony]

Installed the Steeda NHRA legal driveshaft loop today, a little tight around the exhaust hanger that bolts to the tunnel but once you get everything lined up and tightened down everything clears, it will take you a few minutes to get everything lined up and tightened due to the tight clearance.

 

[High Velocity]

I installed some Diode dynamics fog lights. I went with the white version of fog light over the yellow. They look really cool when they are turned on too. I am thinking about doing a blue coyote badge on the grille, what's everyone's opinion on that? Not too sure if I want to do it or not.

 

[Snakebyte]

I installed some Diode dynamics fog lights. I went with the white version of fog light over the yellow. They look really cool when they are turned on too. I am thinking about doing a blue coyote badge on the grille, what's everyone's opinion on that? Not too sure if I want to do it or not.

Nice completed project, and I like your choice of white fog light. Sometimes colors tend to confuse aesthetics.
Speaking of colors and aesthetics, you've already blacked out the pony in the grill to get a clean look, so adding color back could be counter intuitive. But then, if that is what you want...go for it. It is your car to enjoy and do whatever suits YOU.

Sponsored