What did you do to your S550 Mustang today?!

[Joelang33]

Fresh ceramic detail and got up early to take some sunrise pics before work

Sponsored

 

[rum_punch_ruby]

VMP Bap and DW95 injectors. Injectors were a real PITA on the Edelbrock fuel rails but got them in.

 

[B7213]

No, officer, it was the other red, white, and blue Mustang with red wheels

Yea can't deny who's car it was, lol

 

[B7213]

But damn it looks good.

Thanks

 

[frank s]

March 26, approximately 4:30 PM, bid the yellow Yellow YELLOW car adieu, welcomed this:

 

[yellow dog 62]

Last night I installed my Blockit in the trunk and my RockBlockz mud flaps on the front. Will do the rear flaps tomorrow. Fronts look really good.

 

[krishelnino]

Check out this youtube video from LMR at around 5:00. I used this tool and it worked great

Yes i bought that tool after watching the video and doing some research. The mustang rear caliper is a twist and compress mechanism apparently. Installation was very easy using that tool. However the left caliper is damaged i think, i've compressed it all the way in but there's fluid leaking and car is making a weird noise under hard braking. I ordered a new caliper and will swap it along with the front 6-piston Brembos over the weekend.

 

[GMONSTAH]

Got gas...
...at $1.75/gal for 93 at Costco, I’ll hit it up as much as I can. Plus, getting there is full of nice curves and straights...

 

[GMONSTAH]

March 26, approximately 4:30 PM, bid the yellow Yellow YELLOW car adieu, welcomed this:

Congrats!

 

[mysta_sandman]

I spent yesterday installing the Bullitt Brembo Kit on my GT. Currently, my winter tires/wheels are on. I also need to order new shocks/struts. I figured I'm laid off, so I'll just bang out the mods before Summer.

Forgestar just delivered my CF5V. Now I gotta find tires to finish this off.

 

[lacanteen]

Put a strip of Velcro on the tool kit in the trunk to stop it from sliding around. I had a couple of 4' florescent bulbs in there for my kitchen, forgot about them, went on one of my favorite twisty runs and the kit broke one of them. Clean up and learn.

 

[Decanes]

Went for a 300 mile drive on back roads in Ohio

 

[2morrow]

Where to start...

Wrapped up the wiring for the passenger side race seat install, received some newly finished track wheels and decided I needed some smiles per gallon.

 

[VegasSteve2020]

Took off the OEM Blade "spoiler" and installed MMD V-Series Spoiler..

 

[Wolfe]

Went to get an alignment after they installed my Steeda magneride lowering springs.

Haven’t gotten any numbers since I purchased it so figured “why not” while I was there.

Decent gains for a tune and a downpipe.

Anyone looking for a quality shop in the Atlanta area should check out Attitude Street Cars.

Sponsored