What did you do to your S550 Mustang today?!

Blue Moon · Jul 18, 2019

Diamond floor mats are in and look good, but now I'm afraid to let my feet touch the floor.

Elvis66 · Jul 18, 2019

Blue Moon said:
Diamond floor mats are in and look good, but now I'm afraid to let my feet touch the floor.

Socks only

samd1351 · Jul 18, 2019

Blue Moon said:
Diamond floor mats are in and look good, but now I'm afraid to let my feet touch the floor.

Pics or didn't happen!

JK. I do want to see some pics though

Elvis66 · Jul 18, 2019

Mikthehun1 said:
The Jackalope is a noble and gentle creature.

Taste like chicken

2017GBGTPP · Jul 18, 2019

Elvis66 said:
Taste like chicken

Nah, it's actually really gamey.

Scott · Jul 18, 2019

Got the Viking Crusaders double adjustable shocks ready to install. Transferred the jounce bumpers (trimmed off 7/8”) and dust covers over and assembled the shocks onto the BMR Suspensions mounts.

FreedomPenguin · Jul 18, 2019

Installed a Roush Y pipe on my 17 ecoboost with my AWE touring axleback. (its much deeper and throaty in person) I was pleasantly surprised to have a clear, but not raspy/crackle exhaust after the Y pipe. Its the same sound I had, just much louder!

I am pretty happy, around 800-900 for my exhaust invested. Heres a video, but its recorded on an iPhone SE and well, tbh it sounds like poo on my laptop/phone. but its really quite nice.- on positive note, only cost me $10 bucks for lift time/total.

edit. I think I forgot the sticker on the exhaust, whatever. no big deal yeah? I put the clamp right over it probably now thinking about it. shouldn't be any issue.

Sound clip.

jcl78 · Jul 19, 2019

Went from the ear damaging, wake the dead exhaust combo that was on when I bought it a few weeks ago:

Stock exhaust manifolds / stock cats
Resonator delete, welded in H pipe
Welded in Flowmaster 40 mufflers

to:

Magnaflow 11386 resonated X pipe (Tru-X) for the resonator mid section to quiet the rasp and cold startup.
Borla ProXS 40358's for the mufflers
Finished off with the surprisingly excellent quality and low cost Jones Exhaust JST-139 stainless tips (2.5" inlet, 4" Outlet).

Sounds great, no drone, can be stealthy when cruising, nice deep tone when on it. I apologize for the cell phone video.

Stangluvr · Jul 19, 2019

I added a pony emblem license plate frame and some fastener cover/caps with the pony emblem on my 2016 California Special with Roush supercharger.

Blue Moon · Jul 19, 2019

samd1351 said:
Pics or didn't happen!

JK. I do want to see some pics though

Took a couple, but lighting was lousy. I'll share when I get something worth sharing.

243 · Jul 19, 2019

I didn't want any spoiler preferring the look of my old notchback but had no luck finding a naked lid. So I ordered the Foose MMD from American Muscle and it arrived yesterday, took two or three days. It was packed very well and the paint finish and color match are spot on.

The installation was not too bad after I sawed through the factory sticky tape with PowerPro braid. The MMD uses four of nine existing holes and has a continuous layer of two-sided tape around the perimeter to seal the spoiler to the deck lid. I hope it works because I forgot to put at least duct tape over the un-used holes.

Although I would still trade this setup for a naked lid plus cash I am very happy with look compared to the factory PP1 spoiler, it's provides clear visability through the rearview mirror, is much easier to clean and just looks so much better to me.