Show me your boost gauge

[Jeff_oddo]

I'm curious if you've used the ZT-2? If so, where did you tap for boost sensor?

I personally tapped into the vacuum line going to my bypass valve. It plugged into the nGauge Boost+ box and the electrical connector plugged into the back of the nGauge. I'm sure the ZT-2 is very similar

Sponsored

 

[Roh92cp]

I'm curious if you've used the ZT-2? If so, where did you tap for boost sensor?

T from the bypass, vac/boost line to the ZT-2 3 bar MAP sensor which is wired to the ZT-2 box then a small data cable phone style Jack to the Ngauge.

 

[esacteksab]

T from the bypass, vac/boost line to the ZT-2 3 bar MAP sensor which is wired to the ZT-2 box then a small data cable phone style Jack to the Ngauge.

Where did you mount the ZT-2 box?

 

[Roh92cp]

I havn't mounted it yet but it will be underneath the passenger foot well area.

 

[Demon Coyote]

Will this work for all superchargers or only for some. I have a Paxton and was just confirming before ordering one for myself.

heres what I went with.

 

[Roh92cp]

Will this work for all superchargers or only for some. I have a Paxton and was just confirming before ordering one for myself.

It will show boost and vac but will not be accurate.

 

[Demon Coyote]

It will show boost and vac but will not be accurate.

How inaccurate are the boost readings if you don't mind me asking.

 

[Roh92cp]

How inaccurate are the boost readings if you don't mind me asking.

I'm not really sure, I don't have it, but from what I've read they are off a couple PSI.

 

[whatsup62]

I'm not really sure, I don't have it, but from what I've read they are off a couple PSI.

That's about right. I'm running the Ecoboost cluster and the Ngauge with boost+. I am at verified 9psi and Eco gauge shows just over 10.

 

[venumous]

I purchased the Roush 05-09 pod but didn't even use it. Once you pop the vent out the vent flap section can be removed leaving a hex pattern grid on the back of the vent. I just fabricated a small bracket that would hold the boost gauge studs onto the grid and bolted it down with the appropriate nuts I had laying around. This still left plenty of area for air to come through the vent. Drilled two 1/4" holes in the side of the A/C vent pipe and ran the wires up to the fuse box through the sound tube plug same as the boost line.

 

[JadedGT]

Anyone know how much the ecoboost gauge goes for from Ford?

Thx!

 

[DevilDogDoc]

Roush offers one for our cars now, it $56 versus $35 for the old version. Supply and demand I guess...,,,

 

[JadedGT]

Roush offers one for our cars now, it $56 versus $35 for the old version. Supply and demand I guess...,,,

Thx just ordered that gauge. I didn't see this last page with the Roush gauge.

 

[venumous]

Roush offers one for our cars now, it $56 versus $35 for the old version. Supply and demand I guess...,,,

Well shit.. either way don't need it. Would save the money and do what I did again.

 

[jvandy50]

so is there a point if its not accurate? i love that factory guage

Sponsored