Dennisn
Well-Known Member
- Joined
- Apr 28, 2016
- Threads
- 20
- Messages
- 397
- Reaction score
- 133
- Location
- Chicagoland
- Vehicle(s)
- 16 gt
- Thread starter
- #1
So I've been holding off posting my opinion until I got her up and running but here's my impression so far. Keep in mind I started about 7 weeks ago and it's killing me not being able to make any passes at the track. Running on base tune only to datalog for tuner.
Bought the car new about 9 weeks ago. Had opg's and CS installed immediately and ordered up the twins. 55's with the ceramic bb upgrade. As for the install it is a beautiful kit and for the most part straight forward. I believe the installation manual could be a little better. Few spots that would've made things easier if they took better pics. I made notes, if I was smart I would've sent my notes to hellion to maybe help the next guy. Everything done on jack stands in my little two car garage. Couple quick notes to anyone installing the kit. Buy about 3 times as much as the heat wrap and wrap everything. The coolant mods by the oil filter are a pain in the ass. Here's one of the spots where better pics would've came in hand.
I'm trying to do this right from the get go so also did the following
Fore stage one fuel system
Id1000's
Bassani exhaust 3" all the back
Circle d 3b convertor
1400 hp half shafts
Dss one piece driveshaft
Fast forward and got everything installed. After having an issue getting the tune in the car. (That was a **ck story). Car runs smooth. Did an idle log and got the ok to do baby wot pull. Car felt pretty good so I dove into the suspension and did all solid bushing and replaced everything in the rear suspension. Started back on the datalogs and here's where I'm at as of today.
Car has massive knock. I've gone over the kit multiple times checking for anything that'll cause false knock. Did the fresh gas with octane boost and no luck. Still 6 degrees of knock past 3500 rpms. Went so far as to make a couple of pulls on a dyno. On the dyno knock started pulling 2 degrees. Added octane boost let her run and did another pull and knock was under one. Soon as I left the shop made a pull on the street (same fuel everything). 6 degrees knock all the way through the pull. So I'm obviously getting false knock and believe it most likely has to do with road noise/ suspension. One of the problems is if I can't get rid of the false knock timing will be severely retarded.
I'm going to start putting stock suspension back on piece by piece and see if I can't determine what is.causing it then go from there.
The good........... The one pull made 630 rwhp. Only pulled to 6500 and timing was still retarded so car should do pretty good IF I can sort out the issues.
Goal is to make 725-750 on e85 on a nice safe tune.
I will say all these problems has taken all the fun out of having a new car.
Bought the car new about 9 weeks ago. Had opg's and CS installed immediately and ordered up the twins. 55's with the ceramic bb upgrade. As for the install it is a beautiful kit and for the most part straight forward. I believe the installation manual could be a little better. Few spots that would've made things easier if they took better pics. I made notes, if I was smart I would've sent my notes to hellion to maybe help the next guy. Everything done on jack stands in my little two car garage. Couple quick notes to anyone installing the kit. Buy about 3 times as much as the heat wrap and wrap everything. The coolant mods by the oil filter are a pain in the ass. Here's one of the spots where better pics would've came in hand.
I'm trying to do this right from the get go so also did the following
Fore stage one fuel system
Id1000's
Bassani exhaust 3" all the back
Circle d 3b convertor
1400 hp half shafts
Dss one piece driveshaft
Fast forward and got everything installed. After having an issue getting the tune in the car. (That was a **ck story). Car runs smooth. Did an idle log and got the ok to do baby wot pull. Car felt pretty good so I dove into the suspension and did all solid bushing and replaced everything in the rear suspension. Started back on the datalogs and here's where I'm at as of today.
Car has massive knock. I've gone over the kit multiple times checking for anything that'll cause false knock. Did the fresh gas with octane boost and no luck. Still 6 degrees of knock past 3500 rpms. Went so far as to make a couple of pulls on a dyno. On the dyno knock started pulling 2 degrees. Added octane boost let her run and did another pull and knock was under one. Soon as I left the shop made a pull on the street (same fuel everything). 6 degrees knock all the way through the pull. So I'm obviously getting false knock and believe it most likely has to do with road noise/ suspension. One of the problems is if I can't get rid of the false knock timing will be severely retarded.
I'm going to start putting stock suspension back on piece by piece and see if I can't determine what is.causing it then go from there.
The good........... The one pull made 630 rwhp. Only pulled to 6500 and timing was still retarded so car should do pretty good IF I can sort out the issues.
Goal is to make 725-750 on e85 on a nice safe tune.
I will say all these problems has taken all the fun out of having a new car.
Sponsored