sloppymax
Well-Known Member
- Joined
- Jun 2, 2015
- Threads
- 17
- Messages
- 252
- Reaction score
- 70
- Location
- Clover, SC
- Vehicle(s)
- 2015 Mustang GT
I see you were going to change stations, did that happen? On the exhaust, I would check the clamp on the driver side right under the driver. It would not have been loosened by a catback install but it could be loose. 13mm and it can be tightened on the ground if you are not slammed. I would also look at the main clamp where the catback ties to the stock system. There is one clip on each side of the clamp itself that attaches to a small round post. Make sure the clip is under the post when everything is tight. I doubt the air separator is doing anything to cause, if anything it is reducing knock by reducing oil mist and vapors from going back in. If it is still present after addressing that when I would swap back to the stock intake and see if it still resides.Anyone have any other ideas on where this knock is coming from? I'm still getting 3+ degrees with 93 octane plus lucas octane booster. I went through the catback and made sure everything was tight and there was good clearance. Not sure if it could be the jlt oil separator or something with the cai rattling.
Sponsored