Cobra Jet intake install

[Strokerswild]

[MENTION=20642]slowpony[/MENTION] , where'd you get the GT350 CAI?

I assume it bolts directly into a GT and fits and seals properly? Digging the OEM look....

Sponsored

 

[slowpony]

I got it local from a buddy. That's not the whole cold air just the air box. Had to modify the hole piece since it was made for a 4.5' pipe and had to cut a small hole for the MAF sensor plug. Overall it was worth it for me

 

[Strokerswild]

Air box bolts directly in and seals well with the hood?

 

[pinero61]

Joined the CJ club

 

[Chameleon]

Thanks Norm.

 

[pinero61]

Thanks Norm.

Norm is a beast.

 

[dannycoconuts]

I'm going to start install tomorrow, any tips or things to look out for before I start? lol

Sent from my Nexus 6P using Tapatalk

 

[GAS550]

Well instead of building a heat shield I had a GT350 complete cold air intake that included the air box and decided to put some Mexican engineering on it and made it work lol!! The only thing that it didn't come with is the air duct that comes between the grill and the actual air box but I have a lead on one already and hope with the addition of that it will do an even better job and keep the temps closer to ambient.

Before the heat shield this thing will get ridiculous high temps just cruising around about 130-40* and in traffic up to 170-190* that data was in 70* weather . Right now without the air duct I'm seeing 87-93* cruising around and it will get up to about 110-115* in traffic, this is in 83* weather. huge improvement in my opinion and looks factory!!

I'm liking that 350 heat shield! Looks awesome! Does your jlt tube curve down into the box normally or did you have to do something with it?

 

[GAS550]

Joined the CJ club

Lookin good!
So is everyone cutting their hoods, aftermarket hood or lowering your engine?
I lowered my engine.

 

[pinero61]

Lookin good!

So is everyone cutting their hoods, aftermarket hood or lowering your engine?

I lowered my engine.

Lowered engine 1/2".

 

[dannycoconuts]

where is the fpdm? how long will it idle out?

Sent from my Nexus 6P using Tapatalk

 

[dannycoconuts]

nvm going to remove the relay for the fuel pump

Sent from my Nexus 6P using Tapatalk

 

[pinero61]

Throttle mapping is proving to be a PITA

 

[GAS550]

where is the fpdm? how long will it idle out?

Sent from my Nexus 6P using Tapatalk

Under the rear seat on the drivers side.

 

[Chameleon]

I see pics but no driving impressions on CJ intake manifold.

Sponsored