Search results

Tapatalk should have never been dropped. Anyway, I have about 2k miles on mine now. Absolutely no issues to report, and the car comes out the hole pretty damn good.

There's pics of them on my IG gary_tbn

I'd post pics of mine, but this forum is stupid.

Ben Calimer has built MT-82's that go well into the nines.

I run MMR NA grind cams (comp). Unless you're going max effort, I wouldn't touch the cams on FI. If you're seeing valve float, then it may be worth looking into upgrading to custom grinds, VCT lockouts, and valve springs.

I have "big cams" that require locked VCT, and I barely lope. Don't get hung up on it, and enjoy the extra top end power.

With aftermarket axles, these are fairly easy to swap out.

Moving to 4.11's and dropping down to a 26" tire worked wonders for my setup. My setup makes power in a pretty similar way to the 5.2 due to the VCT deletes and 9k redline. The only difference being that the MT82 has a slightly better gearing spread than the 3160. It's a shit gearbox, but at...

Yukon has 4.56's on the docket for this summer. I just put the 4.11's from us gear in my big cam 5.0, love them.

No doubt, like I stated above, VCT is huge for low and mid range torque and subsequently, power. I was going max effort NA, and wanted to turn more RPM than what I felt the phasers could handle. I make peak power at 8,600 RPM, and expect that peak to climb higher after a few exhaust and...

That was stock locked cams versus stock vct enable, correct?

It's not bad, even with big cams this engine is well mannered. Drives like stock with 4.11's.

With those mods, springs, VCT deletes, and MMR s2 (comp grinds) I'm spinning mine out to 9k. That's why i skipped over the NSR cams completely, wasn't worth the money or effort involved for small gains. The redeeming factor of NSR's is the retention of full phaser use. This will help reduce...

For what this car makes still on untouched heads, they do flow very well. I doubt they'd out flow the boss heads, but probably aren't very far off. Ford did a very good job on these engines, with the exception of the OPG's.

There can be slight CR loss when the bowls are reworked, but anything lost would be gained back when the head is decked. Highest ratio shelf stock piston I've found is 12.5:1 from JE. I plan on running these when I do my full build.

With NSR cams, I agree. You're not going to see much of a gain unless you go balls out.

I need to get my hands on a voodoo block and boss heads.....

I had a condo setup and all, but Mitch's wedding is that weekend. I think White Lightning and a few of the other guys from Houma will be there, though.

I can provide one in a few days of mine laid over the stock pull of a GT and a GT 350 to compare how each makes power. Hopefully midway through this coming week. Forewarning, my car makes no torque, lol.

My setup isn't too far off the engine labs build, but you don't need the AEM on the 15+ cars. We're turning up 9k on locked out comp custom grinds (MMR stage 2) with the stock PCM I plan on going full retard towards the end of the year with a full high comp engine build and a 200 shot direct...