help

Stuck between these two exhausts. The Roush cat-back will run me about $750 and is by far the loudest option I’ve heard for the EB. While that’s great, I feel like it’ll be too much at times especially with no valves to control loudness. The MBRP street will be about $450 but doesn’t sound...

So I have a ess g3 supercharger on my car 120mm pulley dynoed at 650 whp on a mustang dyno (reads low) and first week with the kit I snap a driver side axle on a roll idk how but got it replaced with gt350 axles and replaced the diff fluid with new as well and then 3 days later I was just...

Just found out today one of my wheels are bent in the rear, I have a 255/40/19 set up at the moment. Im thinking of replacing the rears with a 17x10 vms wheel with a 305/45/17 tire. Has any one done this before or does any one have recommendations of what size tire to run in the rear. (I make...

2024 Mustang. Yesterday I installed new springs and camber plates on my Mustang, it was my first time doing it and was a fairly easy process. My question is in relation to tightening the top strut bolt on the strut assembly. While out of the car I hit it with an impact quick just to get it going...

Has anyone had this happen? My gas door I couldn’t open the other day to fill my gas tank, the spring inside that you press in to release the door snapped and my door was closed. I bought the part but I can’t seem to figure out how to replace it. These are the two pieces. I took the door...

I’ve developed this annoying rattle that comes and goes, its only at a certain rpm that it happens and has been driving me insane. it sounds like its coming from the interior, towards the driver side rear quarter panel/trunk. Anyone else having this issue? 2015 Mustang GT See attached

Does my APIM come with navigation or not?

2018 GT premium here, got these photos from my dealer, but would like help figuring out what is wrong and what kind of parts I need to get to fix the issues. Just got the car used as well.

Hey guys, I own a 17’ GT350 but did get a gen 2 GT350R motor installed under warranty. I’ve been having some issues with a misfire and have cleaned and tested my injectors, replaced spark plugs, performed a crank re learn and cleaned my MAF sensor. The issue still persists and is now only doing...

Hey guys, I own a 17’ GT350 but did get a gen 2 GT350R motor installed under warranty. I’ve been having some issues with a misfire and have cleaned and tested my injectors, replaced spark plugs, performed a crank re learn and cleaned my MAF sensor. The issue still persists and is now only doing...

So to start, I have a 10AT 2018 ecoboost and have had it since September. It’s CPO and has 38k miles. Car has been relatively perfectly fine but the trans has always been a bit rough going into drive mainly when it’s cold. Would basically just lurch kinda hard every now and then. I read up on a...

Good day, Has anyone seen any guides/instructions on how to rebuild the rear brake calipers on S550 Mustangs? Disassembled them a while back to get powder coated, fast forward half a year later, now putting it back together. My dumb mistake was not documenting it, thinking there will be...

I noticed this coolant hose is dripping onto the exhaust pipe, but I can’t figure out the part number. Does anyone know what hose this is?

Hey everyone, I just bought a 2019 mustang gt premium pp1 and it has been great. I was searching for months to find one in my region with all the packages I wanted and finally found this one. After I bought the car I realized it did not have the active exhaust. I’ve seen a bunch of posts of...

Hi I recently bought a 15 s550 and can’t figure out if it has a tune on it or not ( I believe it has a e85 tune) . It has a lot of upgrades (cold air intake, catch can, lowering springs and paddle assist). It did not come with a tuner. I’m just wanting to know if there’s any device I can buy...

recently picked up a mach 1 bumper with for my 2018 gt was wondering if anybody knew what turn signal/ fog lights are compatible with it because the ones from my previous bumper aren’t also didn’t come with the hardware for install if anybody could help with what is needed

Looking to purchase a new cold air intake system and am debating between a few systems due to price and performance. My first option is the air raid intake junior kit(air raid intake tube with drop in filter) which is around $250. Then the jlt CAI with the closed lid $350. And finally a Roush...

Hi all . I have discussed this with my friend but I want to know if someone else had my problem . Ok let say I’m went for a spin for 20 minutes . When I came back to my garage I’m on 1 gear clutch in and when I want to put in neutral it’s stuck on first gear , for me it seems like is not...

So I have Texas Speed Catted Long Tube Headers for my 2015 mustang gt. I have a corsa extreme catback exhaust and a K&N Drop in filter. The car is STOCK. i was wondering if a tune would be required after installation. i’ve read that you don’t need a tune because it comes with O2 Extensions...