tdstuart
Well-Known Member
My highschool will do it for a few hundred. It will run, just no idea for how long or how much boost it will take lmao.I thought the same. Anyone know someone in AZ that is more fair?
Sponsored
My highschool will do it for a few hundred. It will run, just no idea for how long or how much boost it will take lmao.I thought the same. Anyone know someone in AZ that is more fair?
Exactly. Here in Las Vegas, all the fuel comes via pipeline from California. They don't pump Mobil fuel one day, Chevron the next, Costco the next, etc. They pump 87 one day, 91 the next, etc. The fuel is then picked up at the end of the pipeline and taken to the different locations where they mix in additives, then taken to the gas stations. The only difference between the 91 octane you buy at Mobil compared to Costco is the additives that are added, the base gas is exactly the same. The thing that is not the same is what is in the underground tanks and how long it has sat in those underground tanks at the gas stations, or that the guy delivering the fuel put the wrong stuff in that underground tank. I would be willing to bet Costco probably has the highest turn rate of any gas station anywhere, what other station do you see lines out to the street on a daily basis?Hate to burst everyone's bubble that thinks they are getting some special gas because they bought it at Mobil (or wherever). The truth is, its the same shit, with some unscientifically proven additive that is not proven to do anything anyways....
Agree. But FWIW OP said he was told that AZ ALLOWS gas to be sold with + or - 2 octane numbers from advertised and only Shell or Chevron is known to never be -. I've lived here since '56 and was not aware of that (if true) but then that would be nothing for me to worry about. 91 is the highest available here and I think OP was saying putting 89 (91-2) in a tuned to the edge engine might be a problem.For the record, there is absolutely nothing wrong with Costco gas. Their Top Tier 93 is as good as anything out there.
Facts, dyno shouldn’t be anymore risky than street unless you are just trying to get a high number on the dyno then turn it down.why would you run boostane just for a dyno for a street car? not being a dick but curious. if you're going to be running 93 or 91 on the street all the time, and always filling up with that, why run any different on the dyno. run on the dyno what you're going to run on the street. even if it means settling for lower power. better that than to tune too aggressively and then go burn up your engine on the street.
Maybe OP should get it tested and try to get some compensation from whoever you bought it from if they really think the octane could be lower than the pump said. Hopefully the last x fill ups were from the same place/brand and OP has proof.Did you have the fuel tested? If not you’re really reaching to blame it for you issues. I’m sorry this happened to you. I sucks for sure. But it is reckless to randomly blame the gas without first testing it.
Shhhhhh, don't go telling people that.
![]()
Thinking about this another way, such frequent stock of gas refills could open the opportunity of higher rates of errors during pickup or delivery of fuel to the stations. Having worked in a service station, I have seen the wrong gas being put in the storage tanks more than once.Exactly. Here in Las Vegas, all the fuel comes via pipeline from California. They don't pump Mobil fuel one day, Chevron the next, Costco the next, etc. They pump 87 one day, 91 the next, etc. The fuel is then picked up at the end of the pipeline and taken to the different locations where they mix in additives, then taken to the gas stations. The only difference between the 91 octane you buy at Mobil compared to Costco is the additives that are added, the base gas is exactly the same. The thing that is not the same is what is in the underground tanks and how long it has sat in those underground tanks at the gas stations, or that the guy delivering the fuel put the wrong stuff in that underground tank. I would be willing to bet Costco probably has the highest turn rate of any gas station anywhere, what other station do you see lines out to the street on a daily basis?
Doug
Pretty much the opposite. Costco stations have waiting lines virtually all the time. The fuel they sell is fresher than stations you don't have to wait in line to fill up at. Top Tier means the additives are the highest published standard.I have heard quite a few stories about Costco gas. Not good ones either. I don't understand the concept of using budget gas in a high performance car. The gas may be great, but I suspect there is a storage and/or delivery moisture issue.
So basically you and the tuner did everything wrong.Quick facts:
2015, 9k miles, Whipple stage 2 (only on for 1k miles), Borla cat-back exhaust, billet oil pump gears, catch can. We just acquired the car 1 month ago. First SC car. Tuned/Dyno’d it. Now has bad knock. Probably rod bearings. $9K-10K quote for new short block installed (4700 labor, about 800 misc parts and seals and fees and either 3300 for oem short block or 4800 for Aluminator).
More details:
We were curious of the HP/Torque and also if there was room to improve the Whipple tune so we took the car in to a supposed reputable dyno here in Scottsdale AZ. We were not looking for more power, but efficiency and to know the numbers.
During the first pull, the car was having misfires in cylinder 6. It pulled 638HP , but it faded between 7000 and 7500 RPM. They pulled the plugs and #6 was burning funny. The piston also showed more “burn” and some slight pitting compared to others. Pics attached.
We also suspect potentially bad gas since (us being new to superchargers and high performance was purchasing Costco fuel… oops).
The tuner replaced all the spark plugs and added some racing fuel to bring up the octane to try to play it safe. He proceeded to “tune”, of which all he did was reduce timing by 2.5 degrees and along with that and the plugs and added fuel it suddenly pulled 710HP at 7500 RPM.
Upon removing the car from the Dyno, it had a knock in the motor. The tuner seemed concerned to a degree, but was saying it was probably just a rod that hadn’t pushed down ( or something like that) and said to just keep an eye on it and if it gets worse to stop driving it. Also, he was asking what oil was in the car. I happen to have the invoice from the previous owner and it showed 5w20 and the tuner quickly blamed that saying it was the wrong oil and we needed to change it immediately because it was too thin.
Part of me was feeling stupid for being a novice and not doing more due diligence, and the more I think about this, I’m also mad at the tuner for not doing his due diligence and asking some of theses questions prior to the dyno.
Now faced with 9-10K options, I’m trying to figure the best route to take and also hopefully the fastest because we are thinking about the Aluminator block, but current delivery estimate is 9 weeks (end of January). We are hesitant to do the oem block because this is a good time to make it better and we don’t want this to happen again.
I have so many more thoughts here but will limit myself and let people ask questions and give input.
there is nothing wrong with Costco gas. It comes out of the same damn distribution tanks (10 million gallon tank farms) as all the rest. My EB, GT and 3.5EB all happily suck the 93 down.Who buys & runs Costco or Sam's Club fuel, for a Mustang?
so no in-line test rig/sensors at each distribution port? This sort of thing shouldn't rely on 'luck'. Isn't everyone ISO9001 certified?I have personally hauled a load of STRAIT FUCKING SEAWATER out of a terminal in New Haven, CT before, and delivered it to a gas station, before anyone realized what had happened
unfortunately, this brings up a pretty good point and i think this is a more realistic concern. id like to think such errors are very uncommon but i know better than to assume people wont make mistakes like thisThinking about this another way, such frequent stock of gas refills could open the opportunity of higher rates of errors during pickup or delivery of fuel to the stations. Having worked in a service station, I have seen the wrong gas being put in the storage tanks more than once.
i have literally zero knowledge of the procedures to ensure the proper fuel goes into the proper underground tanks and the rate of error for all this, but i hope it doesnt happen to me, or anyone else here.No, the water sensor in the tank at the station went off when I unloaded it.so no in-line test rig/sensors at each distribution port? This sort of thing shouldn't rely on 'luck'. Isn't everyone ISO9001 certified?
I’ll add my 2c:All, this thread was not meant to be an argument over fuel quality. It was only brought up as a fact that may or may not be helpful. Please, if you want to argue about fuel or give your 2 cents about fuel, start a new thread with that topic…. Or better yet find one of the many that probably already exists.
But on the plus side, M6G gives you double your money back if you don't like what you readAll, this thread was not meant to be an argument over fuel quality. It was only brought up as a fact that may or may not be helpful. Please, if you want to argue about fuel or give your 2 cents about fuel, start a new thread with that topic…. Or better yet find one of the many that probably already exists.