What did you do to your S550 Mustang today?!

[StangSteve]

What was weight savings for the rear seat delete? Can that back part still fold down when needed?

Sponsored

 

[bigwill90]

Rap up the cobra jet install with the circle D converter on the 18..

 

[rum_punch_ruby]

What was weight savings for the rear seat delete? Can that back part still fold down when needed?

My unscientific guess is about 12lbs or so vs the OEM seats. Maybe a tad more without the sound deadening mat I put in.

The upper portion can fold down by unhooking the quicklatches.

 

[Elvis66]

So I take it the red car won?

 

[contender]

Took my mother on a short road trip to the Northeast Classic Car Museum. Great back country roads through farm country. Took a chance on a raffle for a 66 convertible. Wish me luck! :-)

 

[Scott]

Got the Viking Crusaders and BMR mounts installed today.

 

[FUN2RIDEFAST]

As title suggests, this thread will be for 2015 Mustang owners to post pics what they worked on today, show off what they have done to their car recently, etc. Share and it might inspire some ideas for others to do on their Mustangs too.

I'll be getting a tint first thing in the morning and perhaps a car wash, will post pictures shortly!

So, what did you do to your 2015 Mustang today?

Installed my Ngauge with the windshield mount and tomorrow will do a initial data download for Lund. I just wrapped the excess wire around the steering column and since I use the steering wheel in kind of a Down position there was room for it without showing. The excess I tie wrapped and found a place to tuck it above the plug. Looks fine without losing an air vent.

 

[frank s]

Final—I hope—chapter in the Hot Prop Rod Trivial Mods Drama:

Five-sixteenths split wire loom corrugated tubing fits the rod perfectly and has enough insulation properties to soften the painful impact of touching the hood prop rod when it is too hot to handle. Heat shrink tubing 14mm size fits over the loom tube and when shrunk secures the insulation's position on the rod The position is important because the bare sections of the rod lie very close to the radiator cover; the insulated, shrunk part can be accommodated in a depression between the end sections. I put a small piece of the corrugated tubing over the bearing part of the J/L section that anchors the rod to the car, eliminating some slop in that area.

 

[bluefirestarter]

Traded my 2015 base Ecoboost for a Velocity Blue 2019 GT Auto PP1 401a... Absolutely incredible!

 

[loubear911]

Magnet holder, small gun safe, and fixed the seatbelt mounts. Thank you for ECOSVO and FIVETHOUSAND for the idea and instructions on the seatbelt mounts.

 

[Dusten]

whats wrong with the factory straps?

 

[HoosierDaddy]

whats wrong with the factory straps?

Some people want the guide higher up.

 

[lacanteen]

Magnet holder, small gun safe, and fixed the seatbelt mounts. Thank you for ECOSVO and FIVETHOUSAND for the idea and instructions on the seatbelt mounts.

I'm interested in that seatbelt mount. I agree the original is too low for me and the magnetic snap comes loose a lot. Do you have a link or source name?

Sponsored