Crank shaft position code after oil pump gear install?

[Csb1992]

Who else got this code I was told just to do a relearn but just making sure

Sponsored

 

[Travis@boostworks]

I've never had to do a crank relearn after a OPG/Timing gear swap. The only reason you should have to do that is if you remove the flywheel and the crank trigger wheel that's sandwiched between the flywheel/crank gets moved. I could be wrong, though.. Maybe we just got lucky.

What exact code is it throwing?

 

[Rintegration]

Sounds like the engine is out of time. No need for crank relearn if all you did was an OPG

 

[Sagacity]

I had to do a relearn after my crank sprocket, OPG, balancer and whipple install. Not sure which one triggered it though.

 

[Csb1992]

These are the codes that popped up guys
P0017
P0302
P0630
U0422
The last code I figured out its cause I have performance pack wheels and I forgot to tell them and I have a non performance pack car
And I'm thinking code number two might be spark plug cause I did change them

 

[Csb1992]

Also when I idle car sounds perfect doesn't sound like anything is wrong i drove the car an hour home and car ran perfect so idk if it could just be a tune issue I am still on the base Paxton tune through Lund still just data logged waiting on a revision

 

[2-tone]

Sounds like they may have it out of time. It's a fairly common mistake. It's super easy to miss it by a tooth or two if you're not being careful.

The car will appear to run fine, but it needs to be corrected asap.

 

[Csb1992]

Wouldn't it cause the other crankshaft sensor to throw a code also though cause they work in unison?

 

[esacteksab]

Here is what I experienced, when I timed it improperly http://www.mustang6g.com/forums/showthread.php?t=55011

 

[Csb1992]

The only odd part is I only got one camshaft sensor not both and I only have one cylinder misfire and I just though it was odd because they work in unison so it would have been both a and b

 

[terryj]

DTC Symptom chart

Should help some with daignosis

 

[F1scamp]

The only odd part is I only got one camshaft sensor not both and I only have one cylinder misfire and I just though it was odd because they work in unison so it would have been both a and b

If you only have one side of the motor off, it will only throw one cam code. Timing is off.

 

[Csb1992]

Did any of you get a weird noise when you first started the car with new oil pump gears like the engine barely priming oil into oil pump and gears are slightly dry

 

[F1scamp]

Cam tensioners being empty could cause a little racket. What kind of noise?

 

[boosted4life]

Did any of you get a weird noise when you first started the car with new oil pump gears like the engine barely priming oil into oil pump and gears are slightly dry

Just installed mine this weekend along with whipple. No weird noises at all. Had trouble firing though because of loss of fuel pressure when I let it all out but fine now.

Sponsored