Toe alignment

[kevinvan6000]

Replaced the factory k-member in my car with a BMR one. Have an appointment on Wednesday to get an alignment at a shop which is about one mile away from my place. The toe alignment was way out of whack once everything was back together. I did a quick DIY toe adjustment in the garage just to get it to the shop. Right now i have it set 1mm negative toe (front slightly wider than rear). Just want check to see if that should be ok to get it to the shop. Thanks

Sponsored

 

[MrMike]

When I put on the FP Track Handling Kit it looked like I had so much negative toe you could've used a protractor to read the angle of my wheels. You'll be fine getting to the shop, no worries.