Spacers with Factory OEM Wheels

[ZeroTX]

Following this thread, because considering some 20mm spacers on my Black Accent Package wheels (19x8.5's). Not interested in any modification of the car, so was wondering if the recesses on the back of the wheels are enough to not touch the studs.

Sponsored

 

[1 old racer]

I ran 25mm up front and 23 in the rears mostly so they would clear the oem lug studs and it was a perfect fit with pp1 wheels and lowered 1"

 

[ZeroTX]

I ran 25mm up front and 23 in the rears mostly so they would clear the oem lug studs and it was a perfect fit with pp1 wheels and lowered 1"

Who makes/sells 23mm?

 

[1 old racer]

I got them from a company I found on this forum. I will try to remember and let you know. Also my wheel and tire combo were wider then yours. I had 9.0" with 255's up front and 9.5" with 275's out back. Depending on the offset you may be fine with 25mm" all the way around on yours. Something you can do is buy the two 25mm for the front and bolt them out back and if everything looks good the buy the two for the front.

 

[BlueThunder16]

I'd be interested in the 23mm for the rear as well if you happen to remember that company. I want 25s in the front as well, and ideally 20s in the rear but I don't want to have to cut the studs down, so 23 it is. But very hard to find apparently.

 

[Firsttexan]

I run 25mm in front 20mm in rear. Both Eibach. Per Steedas suggestion.

Better use some form of flap or another.

Rocks will blast your rockers and rear fender behind the doors in a matter of a few hundred miles.

Sponsored