Wheel spacers with AMR wheels

[Ant]

I have the staggered set of 19x8.5 and 19x10. 30mm front and 48mm rear. They could use some little help to get a flush look. I know a 20mm bolt on spacer would be too much, so that leaves me with slip on spacers. Not sure which is the maximum to run to still have enough threads to torque the nuts.

Sponsored

 

[cerbomark]

At the minimum, thread engagement length must be equal to or greater than the diameter of the fastener. In other words, if the stud is 1/2-inch in diameter, the nut must engage onto the stud by at least 1/2-inch.

do an internet search, lots of info.