My Custom Audio Build

[thill444]

I'm still using the middle seat bolt area ground down. I tested it at .02 ohms continuity which has been adequate for my two amps totalling 2000watts RMS (1100.5 and 900.5). Albeit i'm only pulling about half to 2/3rds of that right now.

I measured the same. I ended up using the spare tire bolt area because it was a shorter run for my ground cable, but that other bolt was my next choice.

Sponsored

 

[Canoman]

I'm still using the middle seat bolt area ground down. I tested it at .02 ohms continuity which has been adequate for my two amps totalling 2000watts RMS (1100.5 and 900.5). Albeit i'm only pulling about half to 2/3rds of that right now.

How’d you get a ring terminal under the seat bracket? Does a 1/0 ring terminal stretch that far? My 4ga had to be reamed out to fit around the seat bolt, but I can’t sandwich it between the black painted hinge plate and the body. The holes physically won’t like up.

 

[SQ_S550]

Can anybody supply a pic of where this ground location is for OP’s amp? Seems almost everyone uses the bolt in the spare tire well, but I’m looking for one closer to the rear deck/parcel shelf/rear seats.

I drilled a hole on the passenger side of the trunk using a nut and a bolt to secure the ground. Ive since sent to air-ride and moved the ground to the drivers side. Ill see if I have any pics.

Sponsored