Jeffy_2010
Well-Known Member
Use the solid blue, I made the same mistake first go aroundBlue/white
Sponsored
Use the solid blue, I made the same mistake first go aroundBlue/white
Thank you!! It works now!Use the solid blue, I made the same mistake first go around
I installed this and it seems like it is working but when I hold clutch in and press gas to floor all the way it only revs to like 3k but when I let off the gas a little bit it goes to the 4K I have it set to. Can anyone confirm that they are able to press the gas all the way to the floor and it operate correctly?
Mine works correctly so far.I installed this and it seems like it is working but when I hold clutch in and press gas to floor all the way it only revs to like 3k but when I let off the gas a little bit it goes to the 4K I have it set to. Can anyone confirm that they are able to press the gas all the way to the floor and it operate correctly?
Mine works correctly as well, double check all your connections and your wire tap into the clutch lineI installed this and it seems like it is working but when I hold clutch in and press gas to floor all the way it only revs to like 3k but when I let off the gas a little bit it goes to the 4K I have it set to. Can anyone confirm that they are able to press the gas all the way to the floor and it operate correctly?
Excellent I was having the same issue! I had some crazy ideas, thanks god I saw thisHuge thanks to member [MENTION=13877]sonic[/MENTION] for helping me out with PCM circuit identification :cheers:. I was actually trying to help out another member when I decided to change my own activation wiring. Previously I was using ground activation with the lower clutch switch (Blue-Orange wire/pin 9). This works but the 2-step deactivates and goes full throttle when the clutch is just a 1/16" off of the floor and not yet fully engaged. Instead, I changed to the top clutch switch (Green-Violet wire/pin 8). I tap'd into the 22 AWG wire at the bottom of the clutch assembly near the OEM 4 wire connector. Now the 2-step deactivates and the car goes full throttle at the very top of the clutch stoke. Thanks again Sonic
MT82 2-step = use Green-Violet wire for ground activation (either under dash or near PCM)