Modifying As-Built Data Guide

[AngelDeath]

Now just need to compare it to one with the speedo

[MENTION=25893]DanMc85[/MENTION]

720-07-01 Block write fails.

IPC

PN: GR3T-10849-EF
ST: GR3T-14C026-AE
CA; GR3T-14C088-RD

I'll take a look at it after I get back home... that fog change works on the fusion also if someone wanted that as a feature haha. I just had a friend with a newer fusion try it

[MENTION=19066]Epiphany[/MENTION]

Sponsored

 

[Bahndvr]

[MENTION=25081]Agent_S550[/MENTION] ,

I would like to enable the rear diff temp display on my '16 PP; we have the rear diff temp sensor. They have done it with the GT350's.
Is it included in the firmware for the IPC on the GT's?

 

[Agent_S550]

Has anyone found the setting to enable the window auto-up feature? This is disabled for some reason in the 2015 convertibles and I'm hoping it is something that can be changed without needed to change the window switches.

Thanks!

Convertibles do not have bounce back built in. I have the service bulletin stating its unavailable.

 

[Agent_S550]

Yeah. I get that.

But when they built the bosseseses, the keys were pretty much the same until the procal was loaded. Right?

The transceiver or pickup in the column is only capable of reading certain keys to begin with. It won't even be able to decode the id of an incompatible key. Seen it happen with many folks who tried to bring in aftermarket keys that were ford compatible but totally wrong application. Essentially my theory is program a spare key into the track key position. Have it enabled. Try to start the car. See if it's even in the pcm tune to begin with.

 

[Agent_S550]

[MENTION=25081]Agent_S550[/MENTION] ,

I would like to enable the rear diff temp display on my '16 PP; we have the rear diff temp sensor. They have done it with the GT350's.
Is it included in the firmware for the IPC on the GT's?

I would have to look. I don't believe it's available with the ids to adjust and I can't recall if it's even a PID when running diagnostic data. I would like to have mine available on the dash as well. I'm sure it's possible with enough work

 

[DanMc85]

I would have to look. I don't believe it's available with the ids to adjust and I can't recall if it's even a PID when running diagnostic data. I would like to have mine available on the dash as well. I'm sure it's possible with enough work

I am one of the few who thinks IDS is boring lol... I barely use it anymore except to check for module firmware/calibration updates in Module Reprogramming.

Not much in there for programmable parameters for my vehicle.

 

[zuki_dan]

[MENTION=25081]Agent_S550[/MENTION] Do you think it is possible to program and auto key to a car with the manual transmission? Then maybe we could find a way with Forscan to enable remote start in the manual cars.

I know a bypass for the clutch switch would have to be made as well as a switch for the parking brake being engaged that is if the auto key could be programmed to the manual car.

 

[NightmareMoon]

[MENTION=25081]Agent_S550[/MENTION] ,

I would like to enable the rear diff temp display on my '16 PP; we have the rear diff temp sensor. They have done it with the GT350's.
Is it included in the firmware for the IPC on the GT's?

I tried the flipping the same bits that work on the GT350s, and managed to get a Transmission temp display (stuck flatlined at 59'), but no luck yet for the Diff temp. That bit didn't do the trick on my '16 GT PP. I'm going to try to flip some more bits tonight and I'll report back.

 

[dbranger94]

Two more for APIM, grabbed from the F-150 guys and confirmed for my 2016 GT:

Seat Climate Control (if equipped) on Home and Climate Screen
7D0-01-01 xxxx xxxx x2xx enabled, functional
7D0-01-01 xxxx xxxx x0xx disabled

Navigation
7D0-01-02 x2xx xxxx xxxx enabled
7D0-01-02 x0xx xxxx xxxx disabled (Home Screen showing Compass)

I disabled Nav because it's useless in EU until EU maps are available.

I looked at the as-built data from a US GT Premium with Nav and that bit is a 4.

So, mine is 00xx xxxx xxxx and the other is 04xx xxxx xxxx

I'm guessing that it's a region code.

 

[DanMc85]

I looked at the as-built data from a US GT Premium with Nav and that bit is a 4.

So, mine is 00xx xxxx xxxx and the other is 04xx xxxx xxxx

I'm guessing that it's a region code.

He was correct... a vehicle with Nav should be a 2.

 

[dbranger94]

Then what is 04?

The ETIS on that VIN shows with Navigation...

1FA6P8CF7F5430551

 

[dbranger94]

So, is that all you need to do then?

Update 7D0-01-02 to x2xx and get an A7 SD card?

Edit: Nevermind

 

[zuki_dan]

I successfully reprogrammed the APIM to disable the seat controls on the home screen, seemed redundant to me and I never use those buttons on the home screen anyway.

I wasn't successful changing the splash screen. I tried several and all it would show is the pony with the blue background. My car is a 15 premium built 03/15 with sync 2/MFT. Has anybody been able to do this with a similar car? I did notice I also popped and APIM DTC for a configuration error.

 

[Matt P]

I would have to look. I don't believe it's available with the ids to adjust and I can't recall if it's even a PID when running diagnostic data. I would like to have mine available on the dash as well. I'm sure it's possible with enough work

I can see diff temp with the ForScan app on my Android, so the data is there.

 

[Matt P]

[MENTION=25081]Agent_S550[/MENTION],

rocker switches to change driving modes (4 in total, Normal, Sport, Track & Wet/Snow),

I would love to find the module if its not the BCM's as to where the code is to have it remember the last setting the rocker switch was set at.

YES THIS PLEASE!!!

Sponsored