Jeff7814
New Member
- Thread starter
- #1
I have a decent amount of knowledge but I’m overall pretty ignorant when it comes to motors.
my v6 is making a noise but only sometimes
to give the full scope of the car it is a 3.7 v6 that has an auto mafia racing turbo kit on it
I did a pull onto the highway and it didn’t really make a noise but I could tell it changed I thought it blew a coupler which it has done before. As a pulled off the highway a little later I got a low oil pressure light. Instantly pulled over and turned the car off. After I discovered there wasn’t a hole in the block I started it again and it said normal oil pressure but to be safe I towed it home. Some time later I checked and there was no oil so I added some and inspected for a leak it appears as if the rear main seal has a small leak. When I started it back up after I filled the oil again it made the noise in the attached video.
the motor had the pistons replaced with billet aluminum Manley pistons because piston slap destroyed the stock piston skirts.
I drained the oil and there are no metal shavings and the spark plugs have oil coating them there is also oil in the cylinders when I look with a bore scope.
any help is appreciated.
my v6 is making a noise but only sometimes
to give the full scope of the car it is a 3.7 v6 that has an auto mafia racing turbo kit on it
I did a pull onto the highway and it didn’t really make a noise but I could tell it changed I thought it blew a coupler which it has done before. As a pulled off the highway a little later I got a low oil pressure light. Instantly pulled over and turned the car off. After I discovered there wasn’t a hole in the block I started it again and it said normal oil pressure but to be safe I towed it home. Some time later I checked and there was no oil so I added some and inspected for a leak it appears as if the rear main seal has a small leak. When I started it back up after I filled the oil again it made the noise in the attached video.
the motor had the pistons replaced with billet aluminum Manley pistons because piston slap destroyed the stock piston skirts.
I drained the oil and there are no metal shavings and the spark plugs have oil coating them there is also oil in the cylinders when I look with a bore scope.
any help is appreciated.
Sponsored