Sponsored
SheepDog
Well-Known Member
You mean that the instructions and diagram that my 8-year-old niece created for them, aren't good enough?
SheepDog
Well-Known Member
As with any brushed pump setup with the Radium bucket-
Disregard the "W" and "G" posts. These are only to be used for Brushless pumps.
For each pump (1 and 2 labelled on the hat) the "R" is for your power wire, and the "B" is for the ground. Radium did it this way to designate Black and Red. You can confirm this by looking at the bottom side where the pump pigtails connect, and the color of the wires should match up.
The orientation of the Fuel Level sender wires doesn't matter
Disregard the "W" and "G" posts. These are only to be used for Brushless pumps.
For each pump (1 and 2 labelled on the hat) the "R" is for your power wire, and the "B" is for the ground. Radium did it this way to designate Black and Red. You can confirm this by looking at the bottom side where the pump pigtails connect, and the color of the wires should match up.
The orientation of the Fuel Level sender wires doesn't matter
Sponsored
SheepDog
Well-Known Member
My Radium hanger is set up for external/remote pressure regulation, but looking at the pictures, it looks like you simply just loosen the jam nut, and turn the Allen head screw in the desired direction. Your tuner will tell you what base pressure to set (Usually around 45-50 PSI static).
Arcane fuel system users. | Page 2 | 2015+ S550 Mustang Forum (GT, EcoBoost, GT350, GT500, Bullitt, Mach 1) - Mustang6G.com
I think @jonb347 is the owner, or works there if you have more questions
Sponsored
