Chef jpd
Well-Known Member
- Joined
- Apr 1, 2016
- Threads
- 63
- Messages
- 2,989
- Reaction score
- 3,121
- Location
- Brooklyn, NY
- First Name
- John
- Vehicle(s)
- 2020 GT PP1 6M, Grab ass lime. Ex: 2016 EB PPP CO
- Vehicle Showcase
- 1
- Thread starter
- #1
So, since new, I noticed that my headlights were aimed a little too low from the factory. (same on my 2013 ST)
I did some searching and found no other answers except "it can't be done" when looking for ways to adjust.
So, I popped the hood and lo and behold, right on top of the rear of the headlight is an adjustment screw.
and it even has a handy hole for your screwdriver to reach it. 7mm Hex, or small Phillips.
Screw it clockwise to lower and counter to raise it.
no side to side adjustment just horizontal.
I did some searching and found no other answers except "it can't be done" when looking for ways to adjust.
So, I popped the hood and lo and behold, right on top of the rear of the headlight is an adjustment screw.
and it even has a handy hole for your screwdriver to reach it. 7mm Hex, or small Phillips.
Screw it clockwise to lower and counter to raise it.
no side to side adjustment just horizontal.
Sponsored
Last edited: