I posted a WTB post here on the forums. The part number for the PP2 spoiler is JR3Z-6344210-AA and it is the same spoiler that comes on the base Mach 1. The PP2 spoiler is black and the Mach 1 spoiler is magnetic grey.
Thanks! I'll grab some more the next time I have it out.
I removed the back seat to work on swapping the upholstery from cloth to leather and stopped to vacuum out some leaves and dirt from the storage well that the power top folds into. The area underneath that opens up into the trunk was also a part of these cars I’ve never seen documented by photos on this forum before.
Mine or Brians? ( coz his looks more expensive, lol)
Once I finish installing them along with front seat heaters, mine will look pretty expensive… going with a California Special-inspired red and black theme all over the car, and the interior will be this leather and Alcantara suede combo.Mine or Brians? ( coz his looks more expensive, lol)
The one on my GT is the optional OE leather interior with the “midnight blue stitch“. No complaints so far.
I actually like the one from the top pic. (looks like saddle brown?)Once I finish installing them along with front seat heaters, mine will look pretty expensive… going with a California Special-inspired red and black theme all over the car, and the interior will be this leather and Alcantara suede combo.
The brown Katzkin leather is what I have in my Magnetic gray coupe. I considered something similar for the Race Red vert but decided it wasn’t the best match.I actually like the one from the top pic. (looks like saddle brown?)
But that one with red stitching looks epic!
It looks even better in person.I actually like the one from the top pic. (looks like saddle brown?)
But that one with red stitching looks epic!
If you want some premium looking interior, check out Roadwire’s products. They might also do something custom for you.
Are there any guides around that show how to remove the rear seats? I would like to stretch the neoprene covers I have a little tighter, but can’t with the seats in place.A different perspective of Mustang convertibles…
The bottom one is easy, just find 2 tabs underneath (in front) press then lift up. I did this when I installed my CDC light bar. (there’s a YT install video and it shows how easily the bottom rear seat is removed)
There are two clips under the bottom cushion to release it, and then two 15mm bolts holding the back cushion. Once you remove those bolts, lift the back straight up and the clips behind it will be released.