Check your splitter after doing recall!

[TxOilMoney]

If the splitter is not clipped in properly, then the rework is much easier. Just remove the 12 screws that hold it on, the splitter should almost fall off. Reinstall with the top angled upward so the clips catch the pockets. snap it in and install the screws . . . . should take about 5 minutes, once you get the car up where you can work on it.

14 screws. 8 in front, 4 of which are angled at 45 degrees. Six in back with the torx head. 14 just for the center piece. 3 more for each side, plus clips and push pins.

Sponsored

 

[JJones]

Had mine done at baxter ford in omaha...they reinstalled it wrong and it ended up falling off while i was driving it about a week later...needless to say i wasnt happy....:headbonk:

 

[TxOilMoney]

Had mine done at baxter ford in omaha...they reinstalled it wrong and it ended up falling off while i was driving it about a week later...needless to say i wasnt happy....:headbonk:

Unreal. There were a bunch of posts yesterday on the FB page about this same issue. Pathetic service coast to coast.

:thumbdown:

 

[Steve68]

The GT350 Splitter should the the universal symbol of shitty Ford service departments everywhere.

 

[montreal ponies]

That's exactly why i removed my splitter and belly pan.

 

[Tank]

The GT350 Splitter should the the universal symbol of shitty Ford service departments everywhere.

A banged up, bent and twisted one from falling off at highway speed...

 

[JJones]

Does anyone have a link to the install video?

 

[Houston Kid]

The video links can be found here.

http://www.mustang6g.com/forums/showthread.php?t=43097

 

[lemers]

My shop did a good job. I was tge 5th recall they performed so experience matters

 

[FORDSTANGER]

The dealer who sold me the car got it right.

However, the recall dealer messed it up. I'm just going to fix it myself.

Sponsored