Tomster
Beware of idiots
I'll take a picture tomorrow, but I gained oil......After driving yes, a bit below, id say 3/4s in between the etched portions of the stick
Edit to add, thats the exact same spot it was from factory
Sponsored
I'll take a picture tomorrow, but I gained oil......After driving yes, a bit below, id say 3/4s in between the etched portions of the stick
Edit to add, thats the exact same spot it was from factory
You are correct the oil quantity increased.Hold your horses.....
I did exactly the same thing, and it still showed about a half quart low.
Run around the track a whole bunch of times, and the oil quantity increased. I'm not talking about thermal expansion. It was a bit low at 12 qts, now it is a bit high. Id put the 11.5 qts in there.
Interesting. I think we can all agree the engine will not produce more oil, LOL. My uneducated guess would be that the oil filter paper may initially absorb oil, then through more and more heat cycles it loses its ability to absorb and displaces the oil back into the carrying volume capacity.You are correct the oil quantity increased.
I put 11.5 in it seemed low so I added another 1/4 quart still with in the range. After the first on track session checked the oil and the oil was at the high end of the dip stick.
Not sure about the paper filter because the oil level is back to the level before the track session.Interesting. I think we can all agree the engine will not produce more oil, LOL. My uneducated guess would be that the oil filter paper may initially absorb oil, then through more and more heat cycles it loses its ability to absorb and displaces the oil back into the carrying volume capacity.
Than the level should be the same pre track session as after track session.Oil from an oil cooler?
I agree. But my oil level is higher now than before a track day. Normal driving will not duplicate this phenomenon.Than the level should be the same pre track session as after track session.
would a thermostatic oil cooler trap any oil? Only open when the oil gets up to temp then releasing the contents in the line adding to the fill amount? Just thinking out loud.Than the level should be the same pre track session as after track session.