Diff bolt on the rear broke again. I had the bolt replaced once before but I think the bushings the bolt sits in is bad. I already have
Steeda Rear Differential Adjustable Bushing Insert System Urethane GT 2015-2017
in the rear but apparently there are some more bushing I need because I keep...
Misfire code cylinder 8 code again low compression. They pulled the pistion out this time and found a crack in the pistion ring. After picking at the ring it came apart. How does this keep happening? Last time I had cats on the car and I had a misfire code but we never took the pistion out to...
I can't win!!!!!. I haven't had the car back for more then a month. Did the break in period for a thousand miles. New stock short block, only making 10.5 pounds of boost at the most and now I have a misfire code. Took it the shop, they did a compression test on cylinder 8, it was like 100%...
I noticed when I was making a pull while in high rpm I noticed I was losing boost. I'm looking at my boost gauge climb then all of a sudden it started to drop down while in wide open throttle. I thought I was supposed to gain boost the higher I was in the rpm. What's wrong now smh. It's a...
Slammed on the gas I might've seen 1 lb. Of boost. Car drives like the blower isn't on. Feels like an all motor car. Vortech V7JT setup what could it be?
Wrench light came on with the airbag light. What does that mean. Shut the car off. Turned it back on light went away. Car drives normal. Check for codes.... no codes. Comes on whenever it wants
I turn my steering wheel to the right, its stiff like it in track mode times 2 when it's set to normal. Turn it to the left it feels normal, is the best way I can describe it. Anybody had this issue? Is there a power steering module? All I know is the power steering is all electric.
Low oil pressure light is on the dash but the oil pressure gauge In the car says i have plenty of oil pressure. What could cause this problem? I have the PP.
I have a 2015 GT PP .I'm trying to locate all of the control modules located in this car. I noticed in the kick panel on the drivers side and passenger side, there seems to be a computer box but I don't know what they control. Looking for a wiring diagram for this car. I have this issue where I...
Long story short i had a new short block installed with my supercharger. Car starts but has zero throttle response. Throwing random codes that aren't true, low oil pressure generator code etc. They traced every wire and made sure every connection was tight. No pinched wires or loose...
Long story short i had a new short block installed with my supercharger. Car starts but has zero throttle response. Throwing random codes that aren't true, low oil pressure generator code etc. They traced every wire and made sure every connection was tight. No pinched wires or loose...
Motor and supercharger are installed after my cat messed up my motor. No response when I hit the gas pedal. Car starts up and runs and idles fine. Every time I hit the gas a wrench light comes on. Not the tune its mechanical from what I'm told. Has anybody had a issue like this before? Never...
Is anybody using the turbosmart e boost street boost controller? If so where did you mount it to read the boost? Can u post pics where u mounted it ? Thanks
Do you need to re tune your car if you turn up the boost by 1 or two pounds? If your running 10lbs and decide it turn it up to 12, does your car need to be re tuned or will the computer recognize the change on it's own and adjust? Maybe a stupid question just need to know. Thanks
Had my blower on less then a week. I've been getting on since I've had it but i wasn't expecting my cats to fail that fast. I have highflow ARH cats. Turned up the boost to 12lbs, made a couple pulls felt pretty good. On my way home leaving the shop, made a pull in 2nd switched to third and the...
First time I've owned a blower car. I know vortech/paxton dont have the same bottom end torque like a whipple but I was expecting a little more fear factor. I'm tuned for 10.5 pounds but I've only seen 9.5 maybe because its 90 degrees out side... not sure. Car hasn't been on the dyno yet just...