Cathul
Well-Known Member
xx0x is correct, but.... the output from the ACM is always "high-level" in the sense that it's a BTL output. Both wires are carrying a signal. With the "low-level" programming it's just with a lowered output, and therefor not clipping.I think the code for high-level output is 727-01-01 xx0x xxxx xxxx
I would test this with all amplifier gains set to zero as it could be a fixed output level. (I.E. volume control may not work)
I have not played with this so perhaps @Cathul can add his experience here.
On my system, variable line-level out is damn near silent going into my DSP with balanced inputs and I'm completely happy with it.
If you do the signal cable correctly, twisted pair with a shield, you should have similar results as me. (Cat5e STP network cable can be used)
Sponsored